106933 Kenmore Refrigerator - Parts

This door gasket is used to seal the freezer door when closed.

Start relay and overload for production compressor only. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed. The overlay provides added protection against excessive current and against excessive temperature use.

Sold individually.

This ice cube mold and heater assembly has a flake resistant surface. It is used with modular style icemakers on some refrigerators.

This part is the replacement end cap trim for your refrigerator. It is made of white plastic and is approximately 1 inch wide, 1 inch long, and ½ inch thick. This part can also be known as the shelf support retainer as it holds the shelf support in place. If the end cap trim is damaged, the shelf support may not remain in place and you wi...Read morell not be able to store items in your refrigerator door. To replace the end cap trim, carefully disconnect it from both the refrigerator door and the shelf support. Then, snap the new end cap trim into the shelf support and then to the door. This part is sold individually and is an authentic OEM part.

This white door gasket is used to seal the fridge door when closed.

This compression nut is used with the plastic water line of the icemaker assembly.

The bulb is sold separately.

The defrost heater is similar to the burners on an electric stove. It's located just beneath the cooling coils, which are concealed behind a panel in the freezer compartment. The heater gets hot. And, because it's close to the cooling coils, any ice or frost build-up melts.

This high pressure inlet hose washer is black. It is an inch in diameter, made of rubber, and used with many washing machines, refrigerators, and dishwashers.