All Installation Instructions for Kenmore Freezer 1069205580

compressor not running

1 person found this instruction helpful.

Doug from Lancaster, CA
Really Easy
15 - 30 mins

Removed the access panel on back of unit located the Run Capacitor on the compressor and removed the bad one and put the new one on and pugged refrigerator back in and it started up and works fine now

Was this helpful?

Warm refrigerater

1 person found this instruction helpful.

charles from REDDING, CA
Really Easy
15 - 30 mins
Nutdriver, Screw drivers

Followed instructions from ideoo

Was this helpful?

Freezer no longer frost free.

1 person found this instruction helpful.

anthony from NORCROSS, GA
Really Easy
15 - 30 mins
Nutdriver, Screw drivers

Reviewed Youtube video as a reference. Unplugged refrigerator. Removed old defrost timer. Matched the color of the wiring harness to the diagram that came with the part. Attach new part to wiring harness.

Was this helpful?

Needed new gasket for doorknob

3 of 7 people found this instruction helpful.

Nancy from Vernon, TX
Easy
15 - 30 mins
Nutdriver

Brought the inside of the door in tbe house were it was warm. Put gasket on keep inside over night. Screwed frame back on but won't close tigbt so used bungecords to pull tight. Plugged in frezzer left over night next morn took off cord and it sealed great.

Was this helpful?

Shelf studs broke several years ago and I had a problem locating them. Finally wised up and checked Part Direct and found them, ordered the kit w/ 12 pieces. Then quickly watched the installation video. Took less than 30 minutes to replace two different studs. Wife is very happy.

1 person found this instruction helpful.

Karl from BIRDSBORO, PA
Easy
15 - 30 mins
Pliers

Simply took broken pieces of old stud out and replaced with the new ones. Used pliers to adjust them. Replace a freezer stud and a fridge stud.

Was this helpful?

Door would not close wright

1 person found this instruction helpful.

cecil from ATASCADERO, CA
Easy
15 - 30 mins
Nutdriver, Screw drivers, Socket set

Remove top henge, lift door off bottom henge, take off old plastic closer put on new one. Door works great now

Was this helpful?

Renters removed leveling legs from refrigerator. I don't know why!

2 of 4 people found this instruction helpful.

Don from Frankfort, KY
Really Easy
Less than 15 mins

I tilted the unit back enough to scew the new legs into the threaded holes.

Was this helpful?

My wife broke the shelf support

1 person found this instruction helpful.

Hamid from Owasso, OK
Really Easy
Less than 15 mins

The new shelf support part fit perfectly. I needed no tools just slid it on the existing bracket. Super easy.

Was this helpful?

A couple supports broke

2 of 4 people found this instruction helpful.

Michael from Cary, IL
Really Easy
Less than 15 mins

I simply slid off the broken supports, and slid the new ones on.

Was this helpful?

door would not close properly

1 person found this instruction helpful.

John from ATHOL, ID
Very Easy
Less than 15 mins
Nutdriver

removed screw on top cover emptied ref door remove 3 top screws holding bracket on top. lifted the door then remove old cam then reassembled.

Was this helpful?

Light rocker switch broke and refrigerator light couldn't go on.

2 of 4 people found this instruction helpful.

Cathy from HOPATCONG, NJ
Very Easy
Less than 15 mins

I just popped out the old switch with a flat head screwdriver. Removed the connections and then installed new switch by reversing steps. Popped in back in and the light went on.

Was this helpful?

No cold

1 person found this instruction helpful.

Jacqueline from LEXINGTON PK, MD
Very Easy
Less than 15 mins
Nutdriver, Pliers

Like you video

Was this helpful?

The Light Socket Burned Out.

5 of 13 people found this instruction helpful.

MATTHEW from STOCKTON, CA
Really Easy
Less than 15 mins

I pulled the socket out and unplugged the wires. I replaced the light socket by plugging in the wires and snapping the light socket into place. A very simple fix.

Was this helpful?

Broken door stop.

1 person found this instruction helpful.

William from ALBUQUERQUE, NM
Really Easy
Less than 15 mins
Nutdriver

Replaced very easy.

Was this helpful?

Freezer occasionally had a temperature alarm.Clicking noise also.

1 person found this instruction helpful.

Barry from FORD CITY, PA
Really Easy
Less than 15 mins

Was told capacitor was problem 90% of the time.Capacior was not the problem.Bad start relay.

Was this helpful?

1069205580 Kenmore Freezer - Instructions