- Home
- 1068668421
- Instructions
1068668421 Kenmore Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
fan motor did not run all the time
-
Charles from Marion, IN
- Really Easy
- Less than 15 mins
-
Nutdriver, Pliers, Screw drivers
unpluged refrigerator. removed panel in front of fan. Removed the fan motor. Installed the new fan kit. Replaced the panel in front of fan. Pluged the refrigerator back in. The refrigerator runs a 100 percent better
Was this helpful?
Thank you for voting!
not cooling
-
Ted from Crestline, CA
- Really Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
R/R part, 3 screws reconnect 3 wires. easy.
Was this helpful?
Thank you for voting!
water tube froze and got bent so it would not fill ice maker properly
-
Jill from Ivanhoe, MN
- Really Easy
- Less than 15 mins
-
Screw drivers
Removed screws from the back of the part in the fridge. Pulled old part out. Measured the old part. Cut new part to fit. Replaced new part and tightened the screws. Worked perfectly.
Was this helpful?
Thank you for voting!
light would come on and off
-
Dora from Rock Island, IL
- Really Easy
- Less than 15 mins
Viewed the viedo - it showed what to do
Was this helpful?
Thank you for voting!
No Light
-
Mary from Jefferson Township, PA
- Really Easy
- Less than 15 mins
-
Screw drivers
Took socket out and replace it with new one. Very easy. W saved alot of money doing it ourself.
Was this helpful?
Thank you for voting!
.Replace sheared-off freezer shelf support
-
ROBERT from WASHINGTON, DC
- Really Easy
- Less than 15 mins
-
Pliers
First, although I was SURE I knew what to do, I watched the repair video. I used needle nose pliers to push broken support into wall since I could not pull it out. Selected correct wall fixture, spread holder pins, and snapped into wall opening. Couldn't have been easier!!! Very useful site.
Was this helpful?
Thank you for voting!
Frig not cooling.
-
Adam from Randolph, ME
- Really Easy
- Less than 15 mins
-
Pliers
After plugging in the new relay to no avail. I replaced the thermostat. That fixed the problem.
Was this helpful?
Thank you for voting!
exchange of defective light rocker switch
-
Steve from River Edge, NJ
- Really Easy
- Less than 15 mins
-
Screw drivers
1)pry out the old/defective light rocker switch with a screw driver (flat head) and pull out the cables 2)unplug two connectors at the end of light rocker switch 3) connect new light rocker into two connectors 4)push the wires inside and put back new light rocker switch
Was this helpful?
Thank you for voting!
Light in the refrigerator didn't work
-
Anthony from Fairport, NY
- Really Easy
- Less than 15 mins
-
Screw drivers
I did exactly as the video showed. I popped out the old switch, disconnected the two terminals, connected the new switch and put it back. The light now works! The refrigerator is over 25 years old and the switch works! What a great website this is. Couldn't of done the job without Partselect's help.
Was this helpful?
Thank you for voting!
Broken water line connection
-
Carl from Bloomington, IN
- Really Easy
- Less than 15 mins
-
Screw drivers
Very easy to replace. Disconnect water line. remove 2 screws pull out filler tube. replace with new one.
Was this helpful?
Thank you for voting!
Noisy fan
-
Harry from Cincinnati, OH
- Really Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers
Unplug the refrigerator. Remove the rear shelf supports by lifting them straight up. No tools required. Remove the screws holding the rear cover of the freezer. Use a nut driver to remove the 4 screws holding the fan housing. Unplug the wiring harness, then remove the fan and install the new one. Remount the housing, plug in the har
... Read more
ness replace the rear cover, install the shelf supports and plug in the refrigerator. It was 30 minutes start to finish, which includes the time to gather the tools, unload and reload the freezer, and putting the tolls away!
Read less
Was this helpful?
Thank you for voting!
ice maker not making ice
-
judi from wallowa, OR
- Easy
- 15 - 30 mins
-
Screw drivers
repair went well. Ice maker still not making ice. UGH
Was this helpful?
Thank you for voting!
Light switch in the refrigerator was faulty from the first day we installed the fridge.
-
Mary from Wasilla, AK
- Easy
- Less than 15 mins
-
Screw drivers
I had ordered some other parts for something entirely different off your website and service was great. So after almost ten years of a dark refrigerator, because of a defective switch, I decided to see if you had the part to fix it... You did and the part got here in 3 days. I had a working light switch and all the light in the world whe
... Read more
re my husband needed it most (in the fridge). It took me at the most ten minutes to replace the part. All is well now and I have a happy husband who can find the leftovers just fine. Thanks for your great service!
Read less
Was this helpful?
Thank you for voting!
icemaker not working
-
shirley from wind gap, PA
- Really Easy
- Less than 15 mins
-
Nutdriver, Pliers, Screw drivers
I followed vidio instructions, took about 15 minutes. Fridge making great ice cubes again. Felt prouud of the repair I did being 70 years old and a female. Thank you
Was this helpful?
Thank you for voting!
Switch didn't work
-
Don from Laramie, WY
- Easy
- 15 - 30 mins
followed the video as instructed. Saved two repairman calls, one to find the problem, one to install. Net savings was about $130.00
Was this helpful?
Thank you for voting!