10686482 Kenmore Ice Maker - Parts

This screw is sold individually.

Metallic screw that is less than an inch long. Does not include the plastic washer.

There is approximately 10'of wire. Note:2 kits are needed to replace both directions.

This compression nut is used with the plastic water line of the icemaker assembly.

This screw is sold individually.

This screw is sold individually.

This single outlet water valve is intended for use with some commercial ice machines, and not refrigerator icemakers. It comes with a mounting bracket, two screws, and a washer.

These inserts are used with 1/4 inch plastic tubing.

This part helps circulate water through the evaporator to form ice that will be cut into cubes.

This is the mechanics (motor/engine) of the cooling system. It kicks in whenever the thermostat demands cooling. This kit includes the compressor, grommets, drier tube, overload, start relay, run capacitor, wire and terminal cover.

Used on freestanding ice makers.