1067681321 Kenmore Refrigerator - Instructions

All Instructions for the 1067681321
121 - 135 of 183

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
light switch would not work
0 of 2 people found this instruction helpful.
  • Joseph from Destin, FL
  • Really Easy
  • Less than 15 mins
Popped the old one out with a kitchen knife and popped the new one back in. It tool less than 15 seconds!!
Was this helpful?
Thank you for voting!
Bulb Replacement
0 of 2 people found this instruction helpful.
  • Judith from Phoenix, AZ
  • Really Easy
  • Less than 15 mins
I pulled down the wire around the glass cover. . . Released on end of the wire from its holder being careful to not let the glass cover drop. Unscrewed the bulb and replaced with replacement. Easy, easy.
Was this helpful?
Thank you for voting!
The refridgeror side was not cold enough
0 of 2 people found this instruction helpful.
  • Patrick from Sun City, AZ
  • Really Easy
  • 30 - 60 mins
  • Nutdriver, Screw drivers
it was a simple repair once I located the part I had to replace . I really like your speedy delivery of the part I needed Thank you Pat Crotty
Was this helpful?
Thank you for voting!
noisey fan
0 of 4 people found this instruction helpful.
  • Richard from Morgan, UT
  • Really Easy
  • 15 - 30 mins
  • Nutdriver, Pliers, Screw drivers
yup
Was this helpful?
Thank you for voting!
Switch was not working after a repairman had fixed something else
0 of 4 people found this instruction helpful.
  • Jackie from Nova, OH
  • Really Easy
  • Less than 15 mins
Please bear in mind I am 65 years old & it was harder to get up & down off the floor then to change the switch. Was very easy - watched video, unplugged unit. I used the putty knife at the right front corner to work loose, when it came loose had to loose the left side a little. The unit pulled out easily. detached the wired that had a single plug with 2 prongs on it. Attached the plug, pushed new switch into place. There was no way you could place wires on wrong prong. When done, plugged refrigerator back in & checked if working. I CAN SEE THE LIGHT and the food in the freezer now. Thank you for making an easy repair.
Was this helpful?
Thank you for voting!
Broken shelf retainer bar
  • Thomas from Elk Grove, CA
  • Really Easy
  • Less than 15 mins
We broke two shelf retainer bar supports on our 30-year old Whirlpool freezer. PartSelect not only had the part we needed, the price was reasonable, the process was utterly simple and painless, and the parts arrived right on schedule just as promised. The customer experience just doesn't get any better.
Was this helpful?
Thank you for voting!
frosted evaperator
  • Burton from Mount ShaSTA, CA
  • Really Easy
  • Less than 15 mins
  • Screw drivers
I was a Sears repair man for fourty eight years , so I don"t think I should say how easy this was.
Was this helpful?
Thank you for voting!
condenser motor broke
  • patrick from livonia, MI
  • Easy
  • 15 - 30 mins
  • Nutdriver, Pliers, Screw drivers
opened box,read directions,took out bad motor,installed new one.PRESTO CHANGO way to go.
Was this helpful?
Thank you for voting!
high pitch intermittent screech sound coming from within the freezer compartment.
  • Steve from Kent, WA
  • Really Easy
  • 15 - 30 mins
  • Nutdriver, Screw drivers
Unplugged freezer, removed lower shelving, removed panel covering the evaporator motor. Unpluged three wires connected to fan assem and removed. Did not install new wiring that came with kit but installed new motor/fan and reconnected existing wiring. Problem gone!
Was this helpful?
Thank you for voting!
light would come on and off
  • Dora from Rock Island, IL
  • Really Easy
  • Less than 15 mins
Viewed the viedo - it showed what to do
Was this helpful?
Thank you for voting!
No Light
  • Mary from Jefferson Township, PA
  • Really Easy
  • Less than 15 mins
  • Screw drivers
Took socket out and replace it with new one. Very easy. W saved alot of money doing it ourself.
Was this helpful?
Thank you for voting!
exchange of defective light rocker switch
  • Steve from River Edge, NJ
  • Really Easy
  • Less than 15 mins
  • Screw drivers
1)pry out the old/defective light rocker switch with a screw driver (flat head) and pull out the cables 2)unplug two connectors at the end of light rocker switch 3) connect new light rocker into two connectors 4)push the wires inside and put back new light rocker switch
Was this helpful?
Thank you for voting!
The Refrigerator Was Running But Blowing Hot Air, Everything In Freezer Had Defrosted.
  • Jeanne from Fairview Heights, IL
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
First I watched the video on your website, it was quite helpful. It showed me the location of the part to be replaced. Then I used the nut driver to remove a couple of screws, and slowly pulled the cover off . Once I pulled the cover down I could see the part that needed replacing, it had a couple of phillips head screws holding it in place, I removed those screws and unplugged the defrost timer, taking note of the color of the wires. Then I took the new defrost timer and attached the loose wire to the correct terminal according to the directions(this is where the color of your wires comes in), then I plugged in the new defrost timer and replaced the screws. I then reattached the cover making sure not to pinch any of the wires, and replaced the screws. It was so easy I was sure I did something wrong and it wouldn't work, but I plugged the refrigerator back in and let it sit for about 20 minutes and then when I checked it was running cool. I'm 55 years old and never had the nerve to try anything like this before but since my husband passed away I've had to try things myself or replace a lot of appliances. If I can do it anyone can.
Was this helpful?
Thank you for voting!
Light in the refrigerator didn't work
  • Anthony from Fairport, NY
  • Really Easy
  • Less than 15 mins
  • Screw drivers
I did exactly as the video showed. I popped out the old switch, disconnected the two terminals, connected the new switch and put it back. The light now works! The refrigerator is over 25 years old and the switch works! What a great website this is. Couldn't of done the job without Partselect's help.
Was this helpful?
Thank you for voting!
Water was running into refrig from freezer and ice cream was soft
  • William from Delano, MN
  • Really Easy
  • Less than 15 mins
  • Nutdriver
We wasted time looking for the electrical schematic on our refrigerator (the first step in the instructions). By skipping that and reading further in the instructions, the type of cooling that the refrigerator has can easily be determined by the colors of the wires that go to the defrost timer. You need to know this to set up the timer properly for your specific refrigerator. Had I just started there, the entire repair would have taken less than 10 minutes. Very simple repair and it works like a charm, no more water coming into the refrigerator and the ice cream is rock hard. Glad we didn't have to spend lots on a new appliance. Thanks Part Select.com! BH
Was this helpful?
Thank you for voting!
All Instructions for the 1067681321
121 - 135 of 183