- Home
- 1066696021
- Instructions
1066696021 Kenmore Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Freezer not cooling. Temperature rising.
-
Jeff from Austin, TX
- Really Easy
- 30 - 60 mins
-
Nutdriver, Screw drivers
One day the ice cream in the freezer seemed mushy, but the ice was still frozen. There was not water in the ice bin. However, the problem resolved itself. This suggested that the defrost timer had become stuck for an extended time, but then continued to run. The fact that the freezer went back to frozen, implies that all the component
... Read more
s of the cooling loop (compressor, condenser & fan, evaporator & fan) were fine. It was possible that the problem was caused by a bad defrost (?evaporator?) thermostat but everything I saw on line suggested that the defrost timer is the culprit about 40 - 50% of the time. Anyway, I followed the instructions in the on-line video at this site for replacing the defrost timer and it was easy. It would have only taken 15 minutes, but I spent a while reading the defrost timer instructions and hunting down a schematic for my refrigerator, to determine which pin the loose wire should go on.
Read less
Was this helpful?
Thank you for voting!
condenser fan wore out
-
Nancy from Gallatin, TN
- Easy
- 30 - 60 mins
-
Nutdriver, Screw drivers
The kit I recieved was perfect. All parts fit and where a perfect match. I will give you an A+ in handling my order and shocked by speed of your delivery.
Was this helpful?
Thank you for voting!
not cooling could hear a clicking noise
-
Deborah from Elkton, MD
- Easy
- 30 - 60 mins
-
Screw drivers, Socket set
With the help of the website I was able to verify that the part I removed (in the area of the clicking sound) was probably the part required for replacement. I ordered it, installed it... IT WORKS (I knew it the moment I plugged in the power cord and heard the compressor kick on). Saved me from buying a new fridge or calling a repairman.
... Read more
I'm a 58 year old woman with no appliance experience. I watched the videos and installed the part without any trouble. Thank you PartSelect for your easy to use website instructions and helpful hints.
Read less
Was this helpful?
Thank you for voting!
Refrig ran and ran with a lot of hot air coming from the back. Temps in freezer and refrig areas would fluctuate with the unit running almost constantly. Discovered the fan was intermittently running, mostly not.
-
Donald from Strafford, NH
- Easy
- 1- 2 hours
-
Socket set
Removed the old fan; cut the wire and spliced in the new fan and reassembled. A little over one hour. Refrig is working perfectly now with lower settings. It is definitely off much more than on now.
Was this helpful?
Thank you for voting!
blower motor was going out
-
Robert from Batavia, OH
- A Bit Difficult
- 1- 2 hours
-
Pliers, Screw drivers
just had to remove the fan motor the hard thing is getting down to it
Was this helpful?
Thank you for voting!
Fan motor worn out
-
Myrna from Decatur, IL
- Difficult
- 1- 2 hours
My Son who is not an appliance repairman did it for me. He had some difficulty getting the nuts and bolts loose mainly. Sorry I'm not much help other than that! I would like to compliment you on your fast service, first time ordering from you and it was for an older model refrigerator that my repairman said he couldn't find. It's
... Read more
working fine now and I'm a satisfied customer!
Read less
Was this helpful?
Thank you for voting!
wouldn't make ice, door seal was hot to touch, warm in fridge.
-
Dale from Sterling, AK
- A Bit Difficult
- 1- 2 hours
-
Nutdriver, Socket set
I folded in half twice! and took the back off the fridge(cardboard) and took one brace off and just took the screws off the fan from the other two braces. Turned the fan enough to get at the wires for the fan and cut them off an inch from the old fan, stripped the insulation and wire nutted them to new fan. Make sure they don't interfere
... Read more
with the new fan and put the new fan in place put the screws in and we're making ice and cold fridge again.
Read less
Was this helpful?
Thank you for voting!
Refregirator would not freeze properly. It would stay in the defrost mode at times.
-
Eartis from Mckenzie, AL
- Easy
- 30 - 60 mins
-
Nutdriver, Pliers, Screw drivers
I did the repair just as your video showed me. It worked out great.
Was this helpful?
Thank you for voting!
Condenser motor stopped working
-
Chris from Greenville, OH
- Easy
- 30 - 60 mins
-
Pliers, Screw drivers, Socket set
Removed bad motor with socket set and pliers then removed the connectors from the old motor and soldered them on the new one. Then installed new motor. Works like new! Problem Solved! Easy fix!
Was this helpful?
Thank you for voting!
Ice on the botton of top freezer
-
Glenn from Capitol Heights, MD
- Easy
- 30 - 60 mins
-
Nutdriver
I just simply eliminated the ice buildup with hot water and a knife. But I still have the Defrost Timer Kit for future use.
Was this helpful?
Thank you for voting!