106508802 Kenmore Dryer - Instructions

Loosened two screws in back top of drier and pulled forward and up to hinge top of drier and allow access to door switch.Took out broken actuator spring and replaced with new one,snapped lid back in place and put screws back in hinges and job was done.

Very easy to repair remove top of dryer and took out to screws and put switch back in place replaced screws and put top back on. Easy!!

I removed the plastic latch using a screw driver to pry it out. I had to use pliers to completely remove it. Then I snapped the new piece in. It worked perfectly the first time. Very easy repair.

Was informed that I had a bad dryer motor and no warranty. Unplugged the unit. Removed to screws in the lint trap slot. Used a small blade screw driver to pop the 2 clips at the front of the dryer top. Lifted the top and rested it up against the wall. Removed 2 screws holding the machine front panel. Removed the front panel and removed the tub. Couldn't get the blower loose from the dryer motor so I cut it off with a hacksaw. Moral if you are going to replace the motor go ahead and by the blower too. It is less than $20.00. Popped 2 clamps loose holding the motor in and removed it. Placed the new motor in the unit. Strapped it down and attached the new blower. Plugged it in, put the dryer back togehter and tried it. It worked.

Repair was straight forward with only two screws to undo. Popped the two sides in and I was done. What was amazing was the lowest cost on parts and the timely delivery.

Super easy repair. Funny to think I almost called to have it serviced before I found the Door Catch Kit. The original catch had actually fell into the door so when I got the new part it simply snapped in no tools needed!

i watched the video from Part Select. did exactly as seen and presto it was easily done. never could've done it without Part Select.

In a matter of moments the dryer that I had grown to despise was back on my good list! I took a pair of pliers and removed the old parts, then inserted the new catch kit. I only about 5 minutes to do AND I love my dryer again!

same as I described above. However i was amazed when the part showed up the very next day...I was expecting maybe 3 or so days later. I wiil absolutely use PartSelect in the future.

removed the broken part and replaced with the new one

i did not do the repair but when my friend finish it was great, this company is great.

Replaced the cap over the door switch so when the door closed the switch was engaged

I googled the problem, then came across a site where somebody had experienced the same problem, and they changed the door catches to resolve it. I did a search for Whirlpool parts and found "partselect.com". I followed the instructions on the website and located the parts very easily and also discovered that there was a video on how to make this repair. We were tolerating this problem for quite some time and now the problem is resolved, thank you...

I read several customer feedback articles to find one with problem similar to mine. After eliminating the thermal fuse, it was obvious my motor was bad. Watched the video and easily removed motor. Took motor to a repair shop and they confirmed it was bad. Replacement motor arrived in two days (yes...2 days). Unbelievable quick delivery. Easy to reinstall---only took about an hour. Hey, it would have cost $500-$600 to replace this dryer! Now I feel like I have a new dryer for $80!

My husband figured this would be an easy fix....until he realized the part he had turn to remove the motor was made of plastic and was basically welded to the fan, so needless to say, we are now also replacing the fan....once the fan was loose, it was very easy to put in the new motor and fan and reassemble the dryer...good luck and watch out for those plastic moving parts!