All Installation Instructions for Kenmore Refrigerator 10641122213

Crack in vegetable drawer

Emptied draw of contents pulled draw out and inserted new drawer....easy pea-zee

Parts Used:

Paul from NAYLOR, MO
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

6 of 6 people found this instruction helpful.

Was this instruction helpful to you?

All three lights are not working...lights are off but refrigerator still cooling. Also, the control box not lit up to show the temparture for freezer and refrigerator

Used a screw driver to pull old switch. Pulled one wire at a time, only two wires. After wires instlled to new switch push new one back in place where the old one was.

Parts Used:

Refrigerator Door Switch

Antonio from San Antonio, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

7 of 10 people found this instruction helpful.

Was this instruction helpful to you?

freezer light out...Fridge light dim

Previously replaced the Fridge light (control board).. The Fridge and Freezer lights were flickering rapidly...LIghts worked fine for four months...then the freezer light went out completely and the fridge light went dim. I unplugged the freezer light and all lights went out! Hooked it back up and ordered new freezer light. After replacing freezer light all three lights work perfectly at full intensity problem solved...For now!

Parts Used:

LED Light

Scott from CAMBRIDGE, MN
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

6 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Fan motor was making noise.

First I removed all food in freezer.Then removed selves and hanger brackets.Then the back panel and light cover.Then I unplugged motor but before this I unplugged refrigerator from the wall.Removed motor from bracket after pulling of fan. Reversed the order to install motor and put back together

Parts Used:

Evaporator Fan Motor - 120V 60Hz

Fan Grommet

Harry from Mountain Iron, MN
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

6 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Lights Flashing / Strobes

easy peezy - removed old light/module and installed new one works great.

Parts Used:

LED Light Control Board

Darryl from JACKSONVILLE, FL
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

6 of 8 people found this instruction helpful.

Was this instruction helpful to you?

Crisper drawer tilted to the right when pulled out

The repair consisted of lifting up the drawer cover and replacing it. Why the 60 minutes to do that? It took 58 minutes to clean the refrigerator.

Parts Used:

Crisper Cover with Glass

William from Heathsville, VA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins

6 of 8 people found this instruction helpful.

Was this instruction helpful to you?

The Switch Broke...Absolutely Fell Apart.

I simply removed the old switch using 2 small screwdrivers and the old switch case popped out. I then upluged the wires from the old switch and reversed the process. Didn't take longer than 5 minutes begining to end! Thank you for the great service! Duncan quaid

Parts Used:

Refrigerator Door Switch

Duncan from Metairie, LA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

5 of 5 people found this instruction helpful.

Was this instruction helpful to you?

shelves and drawer were cracked.

put new ones in place.

Parts Used:

Refrigerator Slide-Out Shelf with Glass

Refrigerator Crisper Drawer With Handle

Refrigerator Shelf Glass

Crisper Cover with Glass

Esther M from NEW IBERIA, LA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

6 of 8 people found this instruction helpful.

Was this instruction helpful to you?

Raise side of fridge and slide 2x4 under side with broken wheel.

Remove back side cardboard access cover. About 6 dcrews need to be removed. Remove 9/16” bolt and lower compressor tray frame down to slide out wheel axel. Place wheel in slot and replace axel. Lift compressor tray and replace 9/16” bolt. Replace cardboard cover. Remove 2x4.

Parts Used:

Cab Roller

Hans from OGDEN, UT
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Socket set

5 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Plastic side-rail cracked. Shelf could no longer support weight on top or in the drawer beneath.

(1) Remove the drawer by pulling it open until it catches. Push up gently on the bottom-rear of the drawer to lift it over the stop tabs in the drawer rail, and pull the drawer out completely. Note: You will need to push the refrigerator door gently to the fully open position to remove the drawer all the way. The door will open about 30 degrees further than where it comes to rest on its own when opened.
(2) Remove the shelf by lifting gently on the front and sliding it forward. Once the rear corners of the shelf are beyond the upper lip of the shelf rail, you can lift the shelf out of the rail, and turn it vertical to remove through the fridge door. Note: the glass in the shelf is meant to stay in, but if its old or damaged it may tip out when you turn the shelf on its side. So you may want to tape it in place before removing the shelf.
(3) Install the new shelf by repeating step 2 in reverse.
(4) Reinstall the drawer by repeating step 1 in reverse.

Parts Used:

Refrigerator Shelf Frame with Glass

J from BOSTON, MA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

5 of 6 people found this instruction helpful.

Was this instruction helpful to you?

broker cover to crisper

the piece fit perfectly and delivery was within a couple days. very satisfied.

Parts Used:

Crisper Cover with Glass

dean from los angeles, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

5 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Bearings were going out

The refrigerator would make loud sounds humming sounds periodically. The bearings were going out on the evaporator motor. Emptied the freezer side of fridge. Unplugged unit. Took shroud off (6 screws). Removed the three wire clips. Pulled fan off shaft. Carefully pushed plastic strap to remove motor. Replaced with new motor. Carefully attached strap to hold motor. This seems very fragile so be very carefull to attach properly and not break. Reverse the rest and done in less than 15 minutes. 30 minutes cleaning the fridge.

Parts Used:

Evaporator Fan Motor - 120V 60Hz

Doug from North Logan, UT
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

5 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Wife used vacuum cleaner and busted blade off fan

Instructions were great five minutes to remove and replace fan....Thank You............ saved big money

Parts Used:

Fan Blade

Robert from GOSHEN, IN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

4 of 4 people found this instruction helpful.

Was this instruction helpful to you?

fridge stopped cooling then the freezer

Searched my issue on the internet then chose part select to see if bi-metal thermostat was available and it was so I ordered part which was under $30.00 incl. shipping. I then went to You Tube to watch how to replace the part but most importantly to find out where it was located and degree of difficulty. Replacement was rather simple and it fixed our 22 year old fridge. I must add that when I looked up the part it also told you what percent of the time that particular item actually fixed the problem based on others experience. I thought that was neat info. as I felt better about ordering something that may or may not fix my problem. Thank you,

Parts Used: