1024 - Parts
Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Screw
Part #691688
Housing-blower
Part #795071
This is a genuine OEM sourced replacement part that is intended to be used with lawnmower engines from Briggs & Stratton and Toro. The blower housing fits over the engine's flywheel. This item is used to cover and protect the blower fan assembly. This item is sold as an individual replacement part.
Gasket-air Cleaner
Part #795629
Genuine OEM replacement part, this item is sold individually. The 795629 Air Cleaner Gasket is attached to the part number 795259 Air Cleaner Base on one side and to the Carburetor on the other side. Its purpose is to create a seal to prevent small debris and particles from entering the carburetor and engine.
Cover-Linkage
Part #795403
Lawn Mower Spark Plug
Part #796112S
This is an OEM replacement part and is sold individually. Its propose is to deliver an electric current from an ignition system to the combustion chamber of a gas fueled engine. It will ignite the air fuel mixture by the spark. Spark Plugs will usually have to gapped to the manufactures specifications found in the owners manual. Over tim...Read moree a Spark Plug will become fouled because the air/fuel ratio may be set wrong,worn piston rings, carbon build up and other factors. It is better to replace a fouled spark plug, rather then trying to clean it.
Read less
Guard-rewind
Part #691919
This is an OEM part sourced directly from the manufacturer. The rewind guard is commonly found on small engines from Briggs & Stratton. This part is made of high-quality plastic, and is used to cover the starter assembly. This item is sold individually.
Module-oil Sensor
Part #590702
Armature-Magneto
Part #590454
This genuine replacement magneto is designed for Briggs & Stratton engines used in Toro lawn mowers. It plays a vital role in the ignition system by generating the electrical current needed to fire the spark plug. Made from high-quality materials, this part is sold individually.
Note: The spark plug boot is sold separately.
To replace...Read more the magneto, begin by removing the housing or covers from your mower. Next, remove the spark plug and bind the cylinder to prevent it from turning. Disconnect the ignition wires and remove the old ignition coil. Install the new magneto, carefully setting the correct air gap between the coil and the flywheel. Once installed, reassemble the unit and test for proper operation. A screwdriver set is recommended for this repair.
Read less
Link-mech Governor
Part #691829
Seal-o Ring
Part #691031
This authentic item is supplied directly from the original equipment manufacturer for use with engines, outboard motors, portable generators, snowthrowers, and lawn mowers made by Briggs & Stratton and Toro. The o-ring seal attaches to the dipstick. When replacing this part a socket set might be required during the installation process. I...Read moret is made out of rubber and will need to be replaced if it breaks. This part is available as an individual replacement.
Read less
Spacer-fuel Tank
Part #692294
This is a genuine Briggs & Stratton replacement part. The fuel tank spacer is constructed of durable plastic, and is designed for use with many lawn and garden engines. This item is made to fit between the engine and the gas tank. A screwdriver and a wrench may be needed to make the replacement. Please refer to manual and diagrams for further instructions. This part is sold individually.
Retainer-Gov Shaft
Part #690340