1001 - Overview

This is the gasket that helps to provide an air tight seal for the breather assembly. It is a high quality item that is supplied by original equipment manufacturer for use with Briggs and Stratton and Toro equipment. It is made with durable composite material and it is sold individually. Over time gaskets tend to get compressed and deteriorate, eventually requiring replacement.

This manufacturer approved replacement part is specially produced for use with Briggs and Stratton engines commonly installed on Toro lawn and garden equipment. It is utilized to keep the oil in the tank. Please note this durable plastic oil fill cap is sold individually.

Hard starting may come from the recoil system instead of the carburetor or spark plug. If the rope pulls but the engine does not turn, the starter clutch may be worn, dirty, or jammed. The clutch turns the crankshaft during starting and lets go when the engine runs. First inspect the rope, rewind spring, pulley, flywheel screen, and clutc...Read moreh bearing. Confirm fit with the complete engine number. Remove the spark plug wire, wait for hot parts to cool, and keep dirt out of the bearing area. Test free movement before putting the shroud back on.

This is an authentic manufacturer sourced replacement part designed for use with a variety of lawn and garden equipment. This carburetor intake gasket which provides an air tight seal for the carburetor. Over time gaskets tend to deteriorate and would need to be replaced. It is made out of compound material and it is sold individually. You would need a screwdriver to replace this item.

This is an authentic replacement part manufactured for use with Briggs & Stratton small engines. The special retainer is commonly used as spacing between the head of the valve and the valve spring. The retainer is available as an individual replacement part, please see model diagram for associative parts.

This is an OEM replacement part and is sold individually. Its propose is to deliver an electric current from an ignition system to the combustion chamber of a gas fueled engine. It will ignite the air fuel mixture by the spark. Spark Plugs will usually have to gapped to the manufactures specifications found in the owners manual. Over tim...Read moree a Spark Plug will become fouled because the air/fuel ratio may be set wrong,worn piston rings, carbon build up and other factors. It is better to replace a fouled spark plug, rather then trying to clean it.

This is an authentic OEM component from Briggs & Stratton. The magneto armature screw is compatible with many lawn and garden engines. The hardened metal screw helps to mount the magneto armature. A wrench is required for the removal and installation. The magneto armature screw is sold individually. It is recommended to refer to engine manual and diagrams for further instruction.

This is an authentic manufacturer-sourced replacement part which is specially made for use with Briggs and Stratton engines that are commonly installed on Toro lawn and garden equipment. It is a standard hardware which helps to secure the piston. Please make sure to refer to the appropriate diagrams for your model for the correct location...Read more and application of this pin. Keep in mind this high-quality part is made of durable metal and is sold individually. Pliers will be needed to secure or remove it.

The needle valve spring goes next to the idle mixture valve and is made of metal. This is available as an individual replacement part. This authentic item is supplied directly from the original equipment manufacturer for use with engines, generators, tillers, blower-vacuums, and lawn mowers made by Briggs & Stratton and Toro. During repla...Read morecement, it may require a screwdriver and a wrench set to help install this part correctly. It will require replacing if it becomes bent or broken.

This refrigerator evaporator fan motor kit comes with a wiring harness and a four-inch push on fan blade.

This is a complete model #1001 Porter-Cable fixed router base. It is standard on all 690 series routers. It is a fixed base, and does not have a pistol grip handle or plunge functions. This base includes a grooved frame for height adjustment. It is often cheaper to replace the entire #1001 base than to purchase the parts separately...Read more. This is a complete base, and it ships assembled with the sub base, handles, and latch in place.