1001TY2 Porter Cable Router - Overview

This Porter-Cable router sub base is an OEM replacement part. It is found on 690 series routers and allows a router to glide smoothly on the routing surface. This sub base comes complete with the plastic sub base and three countersunk screws for installation.

This replacement collet is an authentic manufacturer-sourced component which is specially designed for use with Porter Cable and Black and Decker routers. Its purpose is to provide a tight grip for securing a router bit. It is a high-quality part which is made of durable metal and it is sold individually, please note the collet nut is sol...Read mored separately. Keep in mind that this collet is for using bits with 3/8" arbors only.

Fits Porter-Cable 8823 batteries only.

Genuine OEM replacement part, this item is sold individually. This Wrench is used to remove and install the collet assemblies on the tools listed below. Two of these wrenches are needed to accomplish this. • One to hold the collet nut. • And one to hold the collet chuck.

This is an Authentic Manufacturer Approved replacement part used on Routers. This part provides a firm grip for holding a bit in a tool. It is made out of Metal and is Sold Individually. This Collet is for using bits with 1/2" arbors only. Includes the 1/2" Collet and a Collet Nut. Due to prolonged, heavy use a Collet may need to be repl...Read moreaced eventually. To replace this Collet you would need to use a Wrench. • First you would need to remove the Collet Nut • Once the Nut is removed you can remove the old Collet • Place a new one in place • Tighten the Collet Nut back in place and your unit is ready to use 1/2" Bits

This is a Genuine Manufacturer Approved replacement part used on some Routers. This part provides the firm grip for holding a bit in a tool. This Collet is for using bits with 1/4" arbors. Due to prolonged, heavy use a collet may need to be replaced. Collet Nut is included in this Assembly.

Genuine OEM replacement part, this item is sold individually. The 874582 Clamp Knob is used to tighten the bases of all of the Routers shown below. It is used with part number 695526 Screw, to clamp the Router Motor in the base for the desired height of the motor.

The shaft attaches to the wear plate and the base housing. This part is made of metal and is available individually. It is a genuine replacement part sourced from the original manufacturer for use with engines and routers made by Porter Cable and Black & Decker. When replacing this item a set of pliers might be required during the installation process. It will require replacing if it becomes broken.

This is a genuine OEM sourced part that is intended to be used with routers from Porter Cable, Delta, and Black & Decker. The metal snap ring is part of the collet and nut assembly. This item is used to fasten the collet and nut together. This item can be purchased as a single item.

This is an authentic OEM sourced replacement part designed for use with routers. This part allows user to secure bits in a tool. This collet is for using bits with 1/4" arbors only. Due to prolonged, heavy use a collets tend to wear out requiring replacement. It is made from strong metal material and it is sold individually. Please note ...Read morethe collet nut is sold separately. To replace this 1/4" collet you will need a wrench. • First you would need to remove the collet nut • Remove the old collet • Secure the new one in place • Tighten the collet nut