092902-166 Briggs and Stratton Engine - Parts

The carburetor assembly was sourced from the original manufacturer to be used with small engines that power lawnmowers. Carburetors are used to mix fuel and air that is sent to the engine's combustion chamber. This assembly is a complete kit that includes the fuel pick up tubes, diaphragm, throttle and choke valves, needle valve, throttle shaft and lever. The part assembly is sold as an individual replacement part.

This is an original replacement part manufactured for use with small lawnmower engines. The pick-up tube is commonly used to pull fuel into the carburetor to mix with air to be sent into the engine's combustion chamber. This special pick-up tube is available as an individual replacement part, please see model diagram for associative parts.

This authentic manufacturer rewind starter spring is a replacement part used in various power equipment engines. It is connected to a pulley system, and it is found inside the starter housing. It is a tightly wound metal spring that stores and releases energy to pull the starter rope back into the housing after starting the engine. If you...Read more are having difficulties starting the engine, or pulling and retracting the starter rope, then the rewind starter spring may be broken or worn down, and in need of replacement. It is recommended to replace the rope at the same time if it is frayed or worn down. Begin this repair by switching off the equipment for your safety. Disassemble the starter housing, and slowly unwind and remove the old spring. Position the new spring in the housing and tension it properly. Reassemble the housing to complete the repair.

Fits 6 gross HP Vertical and Horizontal Crankshaft engines.

This replacement muffler/shield assembly is supplied directly from the original equipment manufacturer for use with Briggs and Stratton engines that are commonly installed on lawn and garden equipment. The purpose of a muffler is to reduce the noise from the engine's exhaust. Over time it may wear out and it can get clogged eventually req...Read moreuiring a replacement to ensure engine's peak performance. It is a high-quality metal body component which is sold individually. A small wrench will be needed to perform this repair.

This pulley-starter is a genuine replacement part sourced directly from the manufacturer. It is compatible with over 150 engines. This pulley-starter is used to start the engine by rotating when the starter rope is pulled. This part is made of plastic, and it should be replaced if it is broken or damaged. Please note this part is sold individually and does not include the starter rope (part 691921).