080252-9480-21 Briggs and Stratton Engine - Parts

This replacement muffler/shield assembly is supplied directly from the original equipment manufacturer for use with Briggs and Stratton engines that are commonly installed on lawn and garden equipment. The purpose of a muffler is to reduce the noise from the engine's exhaust. Over time it may wear out and it can get clogged eventually req...Read moreuiring a replacement to ensure engine's peak performance. It is a high-quality metal body component which is sold individually. A small wrench will be needed to perform this repair.

This authentic manufacturer rewind starter spring is a replacement part used in various power equipment engines. It is connected to a pulley system, and it is found inside the starter housing. It is a tightly wound metal spring that stores and releases energy to pull the starter rope back into the housing after starting the engine. If you...Read more are having difficulties starting the engine, or pulling and retracting the starter rope, then the rewind starter spring may be broken or worn down, and in need of replacement. It is recommended to replace the rope at the same time if it is frayed or worn down. Begin this repair by switching off the equipment for your safety. Disassemble the starter housing, and slowly unwind and remove the old spring. Position the new spring in the housing and tension it properly. Reassemble the housing to complete the repair.

This pulley-starter is a genuine replacement part sourced directly from the manufacturer. It is compatible with over 150 engines. This pulley-starter is used to start the engine by rotating when the starter rope is pulled. This part is made of plastic, and it should be replaced if it is broken or damaged. Please note this part is sold individually and does not include the starter rope (part 691921).

This needle valve kit is an OEM direct from Briggs & Stratton. The kit is compatible with many lawn and garden engines. This item is composed of high-quality metal and plastic components. Fastened to the engine carburetor, the kit carefully controls the fuel flow to the motor. A screwdriver and a wrench set is often required for the proper repair. The needle valve kit is sold individually.

This item is an authentic part that is OEM sourced to ensure quality. The oil seal is intended to be used with small engines from Briggs & Stratton and Toro. This item is used to prevent leaks and to stop contaminants from entering the space between the crankshaft and the crankcase. This seal is priced as a single item.

It is a genuine replacement part that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. This specially designed grip is secured to the starter rope to provide a user with a comfortable grip for starting the engine. It is a high-quality item that is made of durable black plastic and it is sold individually.

Genuine Manufacturer Approved replacement part used on a variety of Engines. This is a tube pick-up for 3-5HP horizontal and 5HP vertical engines with 2 and 3 quart tanks and a pulsa jet carburetor. This part is made out of Plastic and it is Sold Individually.