030536-0 Briggs and Stratton Generator - Parts

This is a genuine Briggs & Stratton part sourced directly from the manufacturer for use in generators. The outlet is made of metal and plastic and attaches to the control panel. A screwdriver may be necessary during the installation of this item. It may become broken and will need to be replaced. This is available as an individual replacement part.

This is a genuine replacement part sourced directly from the manufacturer. The valve fuel kit is commonly found in Craftsman pressure washers and generators. This part includes the valve made of high-quality plastic, and a rubber cap. It is used to carry fuel from the tank into the engine. You may require a screwdriver or Allen wrench when replacing this item.

This is an OEM part sourced directly from the manufacturer. The bearing carrier is commonly found in generators from Briggs & Stratton and Snapper. This part is made of metal, and is used to hold one end of the stator assembly and the brush holder. You will require a wrench when replacing this item. This product is sold with a flexible rubber O-ring.

The circuit breaker is made out of plastic and metal. This authentic item is supplied directly from the original equipment manufacturer for use with generators made by Briggs & Stratton. This item is available as an individual replacement part. During the installation process, a screwdriver and a set of pliers might be needed to replace this part. It might break over time and will need replacing.

This bottle of oil can be used in over 150 different types of machinery. It is most commonly used for pressure washers and generators from manufacturers such as Briggs and Stratton and Troy-Bilt. This detergent oil is warranty approved and specially compounded for warm weather use. Please note: it is important to avoid over filling your engine with oil.

The set exercise switch attaches to the hour meter. This is a genuine Briggs & Stratton part sourced directly from the manufacturer for use in generators. This part is available as an individual replacement. It is made of plastic and metal and may require a wrench during installation. It might become broken and will need to be replaced.

This brush holder assembly is an authentic OEM replacement part that is specially designed for use on Briggs and Stratton generators. Brushes help to conduct electric current in the motor that powers the unit. This assembly includes one plastic brush holder and two carbon brushes with a lead wires and springs attached. You would need a screwdriver to complete this job.