020713-00 Briggs and Stratton Pressure Washer - Parts

The engine mounting hardware kit is sold as a set that contains all the necessary parts. These are genuine items that are supplied by the original equipment manufacturer for use with pressure washers made by Briggs & Stratton, Troy-Bilt, and Snapper. A wrench set might be necessary during the installation of these parts. These items might break over time and will need replacing.

This is an authentic replacement part manufactured for use with pressure washers. The nozzle is used to provide an even spray when using soap or a chemical cleaner. This black soap nozzle is available as an individual replacement part, please see model diagram for nozzle kits for a specific model pressure washers.

This is an authentic manufacturer made replacement part which is specially designed for use with Craftsman pressure washers. The wheels are attached to the bottom of the pressure washer and are used for transporting it from place to place. This part is made of rubber and metal and is sold individually, though two are required for the unit. For installation, you will need a socket wrench and a screwdriver to aid you.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton and Troy-Bilt pressure washers. The purpose of these components is to provide an air-tight seal between connected parts, please make sure to refer to the appropriate diagrams of your model for the correct location and a...Read morepplication of this hardware. Keep in mind this high-quality kit is sold individually, note that it includes six durable rubber seals.

This bottle of oil can be used in over 150 different types of machinery. It is most commonly used for pressure washers and generators from manufacturers such as Briggs and Stratton and Troy-Bilt. This detergent oil is warranty approved and specially compounded for warm weather use. Please note: it is important to avoid over filling your engine with oil.

This is a genuine OEM sourced replacement part that is intended to be used with pressure washers from Craftsman. The screen fits into the water inlet tube and is used to prevent debris from the hose from entering the pump assembly. This item is available as an individual replacement part.

This genuine OEM sourced replacement part is designed for use with pressure washers. If the pressure washer runs too long with out the release of water from the sprayer, the water will heat up inside the pump. Once the water gets to a certain temperature the thermal valve will open and release the pressurized hot water, to protect the pum...Read morep. If this happens too often you have a greater chance of damaging your pump. This valve consists of one (1) metal and one (1) plastic piece. To complete this repair you will need a wrench.

This is a genuine OEM sourced replacement plug kit which is designed for use with Briggs and Stratton and Troy-Bilt pressure washers. This kit includes three high-quality pligs and a tube of lubricant. Unfortunately, over time parts may wear out or get damaged eventually requiring a replacement. Check the appropriate diagrams for your mod...Read moreel to ensure the correct repair procedure. A wrench set might be needed to remove the old plugs and secure the new ones.

This item is an authentic OEM sourced O-ring kit that replaces worn or damaged O-rings for the gun, hose and wand.Unfortunately, over time o-rings will wear out and they may begin to crack eventually requiring replacements. Refer to the appropriate diagrams for your model to ensure the correct replacement procedure. A screwdriver and a wr...Read moreench set might be needed to take apart and reassemble the equipment. Note, this kit is sold as an individual item.