020689-00 Briggs and Stratton Pressure Washer - Parts

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton and Troy-Bilt pressure washers. The purpose of these components is to provide an air-tight seal between connected parts, please make sure to refer to the appropriate diagrams of your model for the correct location and a...Read morepplication of this hardware. Keep in mind this high-quality kit is sold individually, note that it includes six durable rubber seals.

This is an authentic OEM sourced replacement part that is intended to be used with pressure washers from Troy-Bilt and Briggs & Stratton. The red nozzle is 0-¦ and attaches to the end of the spray wand. This nozzle emits a small concentrated stream of water. The red nozzle is used to remove tough stains in concrete and metal. It is advise...Read mored to not use this nozzle on wood or siding because this nozzle produces a powerful stream that can damage soft materials. The red nozzle is sold as an individual replacement part.

This is a genuine OEM sourced replacement part that is intended to be used with pressure washers from Craftsman. The screen fits into the water inlet tube and is used to prevent debris from the hose from entering the pump assembly. This item is available as an individual replacement part.

This genuine OEM sourced replacement part is designed for use with pressure washers. If the pressure washer runs too long with out the release of water from the sprayer, the water will heat up inside the pump. Once the water gets to a certain temperature the thermal valve will open and release the pressurized hot water, to protect the pum...Read morep. If this happens too often you have a greater chance of damaging your pump. This valve consists of one (1) metal and one (1) plastic piece. To complete this repair you will need a wrench.

This item is an authentic OEM sourced O-ring kit that replaces worn or damaged O-rings for the gun, hose and wand.Unfortunately, over time o-rings will wear out and they may begin to crack eventually requiring replacements. Refer to the appropriate diagrams for your model to ensure the correct replacement procedure. A screwdriver and a wr...Read moreench set might be needed to take apart and reassemble the equipment. Note, this kit is sold as an individual item.

The check valve is an authentic OEM part for pressure washers made by Briggs & Stratton and Troy-Bilt. During the installation process, a screwdriver might be needed to replace this item. This part is made out of plastic and metal and will need to be replaced if it breaks. It is sold as a set of six valves.

This is an authentic OEM part for use with Craftsman Pressure Washers. The quick connector also is known as the wand connects to the spray gun handle and houses the nozzle that directs the spray stream. The most common reason for replacing the wand is if it is leaking or damaged. This part is sold individually. The tool that you will need to replace the wand is Silicone grease (optional).

This is a genuine component which is supplied by the original equipment manufacturer for use with Briggs and Stratton, Snapper and Troy-Bilt pressure washers. The quick change nozzle delivers a consistent spray pattern for pressure cleaning applications. It provides an identical replacement for a missing or a faulty component that came wi...Read moreth the new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this part. Keep in mind this high-quality nozzle is sold individually.