020575-01 Briggs and Stratton Pressure Washer - Parts

This is an authentic OEM replacement part for use with the pressure washers listed below. It is a quick connect nozzle with a zero (0) degree, straight line spray width. This cutting nozzle is the strongest stationary nozzle and is recommended for use on strong hard surfaces, as it can cause paint removal or scratches. Sold individually.

This is an authentic replacement part manufactured for use with pressure washers. The nozzle is used to provide an even spray when using soap or a chemical cleaner. This black soap nozzle is available as an individual replacement part, please see model diagram for nozzle kits for a specific model pressure washers.

This water inlet kit delivers a controlled supply of water into the appliance, supporting proper operation during use. Designed for dependable flow and secure connections, it is commonly replaced when water supply issues or leaks occur.

This is a genuine OEM sourced component which is specially designed for Craftsman pressure washers. It is an identical replacement for a missing or damaged outlet that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application of this item. Keep in mind this high-quality part is made of durable metal and is sold individually.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton and Troy-Bilt pressure washers. The purpose of these components is to provide an air-tight seal between connected parts, please make sure to refer to the appropriate diagrams of your model for the correct location and a...Read morepplication of this hardware. Keep in mind this high-quality kit is sold individually, note that it includes six durable rubber seals.

This is a genuine OEM sourced replacement part that is intended to be used with pressure washers from Craftsman. The screen fits into the water inlet tube and is used to prevent debris from the hose from entering the pump assembly. This item is available as an individual replacement part.

This authentic manufacturer-sourced replacement fuel tank assembly is produced for Briggs and Stratton and Troy-Bilt pressure washers. The purpose of this part is to hold the chemical solution that is used by the unit. It is made of high-quality plastic and is sold individually, it includes the tank, the lines, and the cap. Over time it m...Read moreay wear out and begin to fail eventually requiring a replacement, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component.

This genuine OEM sourced replacement part is designed for use with pressure washers. If the pressure washer runs too long with out the release of water from the sprayer, the water will heat up inside the pump. Once the water gets to a certain temperature the thermal valve will open and release the pressurized hot water, to protect the pum...Read morep. If this happens too often you have a greater chance of damaging your pump. This valve consists of one (1) metal and one (1) plastic piece. To complete this repair you will need a wrench.

This item has been sourced from the original manufacturer to be used with pressure washers from Briggs & Stratton and Troy-Bilt. The fuel valve attaches to the fuel tank and is used to link the fuel line and to regulate the flow of fuel. This item is sold as an individual replacement part.