020573-00 Briggs and Stratton Pressure Washer - Parts

This is a genuine OEM sourced component which is specially designed for Craftsman pressure washers. It is an identical replacement for a missing or damaged outlet that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application of this item. Keep in mind this high-quality part is made of durable metal and is sold individually.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton and Troy-Bilt pressure washers. The purpose of these components is to provide an air-tight seal between connected parts, please make sure to refer to the appropriate diagrams of your model for the correct location and a...Read morepplication of this hardware. Keep in mind this high-quality kit is sold individually, note that it includes six durable rubber seals.

This is a genuine OEM sourced replacement part that is intended to be used with pressure washers from Craftsman. The screen fits into the water inlet tube and is used to prevent debris from the hose from entering the pump assembly. This item is available as an individual replacement part.

This is a genuine item that is supplied directly from the original equipment manufacturer for use with Troy-Bilt and Briggs and Stratton pressure washers. It is an identical replacement for a missing or a faulty handle fastening kit that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for t...Read morehe correct location and application of these components. This high-quality kit is sold individually, keep in mind it includes two durable plastic grips and two bolts to secure them.

This genuine OEM sourced replacement part is designed for use with pressure washers. If the pressure washer runs too long with out the release of water from the sprayer, the water will heat up inside the pump. Once the water gets to a certain temperature the thermal valve will open and release the pressurized hot water, to protect the pum...Read morep. If this happens too often you have a greater chance of damaging your pump. This valve consists of one (1) metal and one (1) plastic piece. To complete this repair you will need a wrench.

This is a genuine OEM sourced replacement plug kit which is designed for use with Briggs and Stratton and Troy-Bilt pressure washers. This kit includes three high-quality pligs and a tube of lubricant. Unfortunately, over time parts may wear out or get damaged eventually requiring a replacement. Check the appropriate diagrams for your mod...Read moreel to ensure the correct repair procedure. A wrench set might be needed to remove the old plugs and secure the new ones.

This battery charger is used with a variety of portable generators. It is supplied directly from original equipment manufacturer and it is sold individually. It is used to deliver power from an outlet to the unit. Please note that a weak or defective battery can damage the charger. Weak batteries are batteries with bad cells that would no...Read moret hold charge. It is advised to test your batteries if you are unsure if the problem is in the charger or the batteries.

This is a genuine part that is used to replace the original hose that is used with pressure washers from Briggs & Stratton and Snapper. The clear plastic hose is used to relay liquid soap from the detergent reservoir and the pump assembly. This item is available as an individual replacement part.

It is an authentic high quality item that is supplied from original equipment manufacturer for use with Briggs and Stratton and Troy-Bilt pressure washers. This kit attaches to the base of the pressure washer to reduce vibration when the unit is turned on. This kit includes two durable rubber mounts, two metal washers, two bolts and two lock nuts.