020570-02 Briggs and Stratton Pressure Washer - Parts

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton and Troy-Bilt pressure washers. The purpose of these components is to provide an air-tight seal between connected parts, please make sure to refer to the appropriate diagrams of your model for the correct location and a...Read morepplication of this hardware. Keep in mind this high-quality kit is sold individually, note that it includes six durable rubber seals.

This is a genuine OEM sourced replacement part that is intended to be used with pressure washers from Craftsman. The screen fits into the water inlet tube and is used to prevent debris from the hose from entering the pump assembly. This item is available as an individual replacement part.

This genuine OEM sourced replacement part is designed for use with pressure washers. If the pressure washer runs too long with out the release of water from the sprayer, the water will heat up inside the pump. Once the water gets to a certain temperature the thermal valve will open and release the pressurized hot water, to protect the pum...Read morep. If this happens too often you have a greater chance of damaging your pump. This valve consists of one (1) metal and one (1) plastic piece. To complete this repair you will need a wrench.

This is a genuine OEM sourced replacement plug kit which is designed for use with Briggs and Stratton and Troy-Bilt pressure washers. This kit includes three high-quality pligs and a tube of lubricant. Unfortunately, over time parts may wear out or get damaged eventually requiring a replacement. Check the appropriate diagrams for your mod...Read moreel to ensure the correct repair procedure. A wrench set might be needed to remove the old plugs and secure the new ones.

This is an authentic OEM part for use with Craftsman Pressure Washers. The quick connector also is known as the wand connects to the spray gun handle and houses the nozzle that directs the spray stream. The most common reason for replacing the wand is if it is leaking or damaged. This part is sold individually. The tool that you will need to replace the wand is Silicone grease (optional).

It is an authentic high quality item that is supplied from original equipment manufacturer for use with Briggs and Stratton and Troy-Bilt pressure washers. This kit attaches to the base of the pressure washer to reduce vibration when the unit is turned on. This kit includes two durable rubber mounts, two metal washers, two bolts and two lock nuts.