020291-3 Briggs and Stratton Pressure Washer - Parts

This is an authentic OEM part from Briggs and Stratton, Troy-Bilt, and Snapper for use with Pressure Washers. The Briggs & Stratton Pressure Washer Pump Saver prevents harmful buildup of hard-water mineral deposits in the pump, maintains pump seals and pistons and promotes longer pump life. It contains anti-freeze to protect the pump from...Read more freezing and provides safe winter storage. This part is sold individually. No mixing, stirring or shaking is required. Just attach the pump saver to the pump and dispense.

This is a genuine OEM sourced replacement part that is intended to be used with pressure washers from Craftsman. The screen fits into the water inlet tube and is used to prevent debris from the hose from entering the pump assembly. This item is available as an individual replacement part.

This is a genuine item that is supplied directly from the original equipment manufacturer for use with Troy-Bilt and Briggs and Stratton pressure washers. It is an identical replacement for a missing or a faulty handle fastening kit that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for t...Read morehe correct location and application of these components. This high-quality kit is sold individually, keep in mind it includes two durable plastic grips and two bolts to secure them.

This is an authentic OEM part for use with Craftsman Pressure Washers. The wand connects to the spray gun handle and houses the nozzle that directs the spray stream. The most common reasons for replacing the spray wand are when it is worn-out or is leaking. This part is sold individually. The tool that you will need to replace the wand is a 5/8 inch wrench. Shut the pressure washer off before installing the wand.

Pressure washer pump kit. If the pressure washer is leaking water, the pump may need to be rebuilt or replaced. If the pump is more than a few years old, and you use the pressure washer fairly often, replace the pump.

This genuine OEM sourced replacement part is designed for use with pressure washers. If the pressure washer runs too long with out the release of water from the sprayer, the water will heat up inside the pump. Once the water gets to a certain temperature the thermal valve will open and release the pressurized hot water, to protect the pum...Read morep. If this happens too often you have a greater chance of damaging your pump. This valve consists of one (1) metal and one (1) plastic piece. To complete this repair you will need a wrench.

This item is an authentic OEM sourced O-ring kit that replaces worn or damaged O-rings for the gun, hose and wand.Unfortunately, over time o-rings will wear out and they may begin to crack eventually requiring replacements. Refer to the appropriate diagrams for your model to ensure the correct replacement procedure. A screwdriver and a wr...Read moreench set might be needed to take apart and reassemble the equipment. Note, this kit is sold as an individual item.

This is sold as a kit and will need to be replaced if it becomes broken. The unloader kit is made out of metal and helps to control the water pressure. It is a genuine Briggs & Stratton and Troy-Bilt part sourced directly from the manufacturer for use in pressure washers. When replacing this item, a wrench and a set of pliers might be required during the installation process.

This replacement hose is a genuine OEM sourced item that specially produced for use with Craftsman pressure washers. This 25 ft. high-pressure hose is made of durable rubber with metal fittings and it is sold individually. It can be used on pumps that produce up to 2600 PSI. Over time the material may deteriorate or get damaged eventually requiring replacement to maintain a working unit.