020214-0 Briggs and Stratton Pressure Washer - Parts

This is a genuine OEM sourced component which is specially designed for Craftsman pressure washers. It is an identical replacement for a missing or damaged outlet that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application of this item. Keep in mind this high-quality part is made of durable metal and is sold individually.

This bottle of oil can be used in over 150 different types of machinery. It is most commonly used for pressure washers and generators from manufacturers such as Briggs and Stratton and Troy-Bilt. This detergent oil is warranty approved and specially compounded for warm weather use. Please note: it is important to avoid over filling your engine with oil.

This is an authentic OEM part for use with Craftsman Pressure Washers. The wand connects to the spray gun handle and houses the nozzle that directs the spray stream. The most common reasons for replacing the spray wand are when it is worn-out or is leaking. This part is sold individually. The tool that you will need to replace the wand is a 5/8 inch wrench. Shut the pressure washer off before installing the wand.

This genuine OEM sourced replacement part is designed for use with pressure washers. If the pressure washer runs too long with out the release of water from the sprayer, the water will heat up inside the pump. Once the water gets to a certain temperature the thermal valve will open and release the pressurized hot water, to protect the pum...Read morep. If this happens too often you have a greater chance of damaging your pump. This valve consists of one (1) metal and one (1) plastic piece. To complete this repair you will need a wrench.

This item is an authentic OEM sourced O-ring kit that replaces worn or damaged O-rings for the gun, hose and wand.Unfortunately, over time o-rings will wear out and they may begin to crack eventually requiring replacements. Refer to the appropriate diagrams for your model to ensure the correct replacement procedure. A screwdriver and a wr...Read moreench set might be needed to take apart and reassemble the equipment. Note, this kit is sold as an individual item.

This replacement hose is a genuine OEM sourced item that specially produced for use with Craftsman pressure washers. This 25 ft. high-pressure hose is made of durable rubber with metal fittings and it is sold individually. It can be used on pumps that produce up to 2600 PSI. Over time the material may deteriorate or get damaged eventually requiring replacement to maintain a working unit.

Genuine OEM replacement part, this item is sold in a kit. This is the part of the pressure sprayer that threads into the pump(First in, Spring then the Ball). The the chemical hose kit connects to it. Then the chemical hose kit is placed in the material (soap) that you want to use to clean the surface you want.

It is a genuine OEM sourced item that is designed for Briggs and Stratton, Snapper and Troy-Built pressure washers. The manifold housing is an important component that attaches to the pump head. It houses the unloader valve, the check valves, the outlet tube and the chemical injection assembly. If the manifold housing is worn or damaged i...Read moret can cause water leaks and it should be replaced to ensure the equipment is functioning properly. To determine the exact location and the correct installation of this manifold housing, refer to the appropriate diagrams of your model. You will need a screwdriver and a wrench set to perform this repair. This high-quality manifold housing is made of durable metal and is sold as an individual component.

This item has been OEM sourced to ensure quality. The clear plastic hose is intended to be used with pressure washers from Troy-Bilt and Briggs & Stratton. This part includes the fittings at the ends. The hose is used to carry chemicals or soap from the detergent tank to the pump when using the machine to clean. This item is available as an individual replacement part.