Kenmore Dryer Belts
- Search your model number to find:
- Genuine OEM parts guaranteed to fit
- Free manuals and guides
- Repair instructions and videos
Popular Kenmore Dryer Belts
Kenmore Dryer Multi Rib Belt - 92-1/4"
PartSelect Number PS346995
Manufacturer Part Number 341241
This dryer drum belt has four ridges, three grooves and is 1/4" wide.
Fixes these symptoms
- Drum Not Spinning
- Heat stays on after drum has stopped
- Noisy
- See more...
Kenmore Dryer Repair Kit
PartSelect Number PS373088
Manufacturer Part Number 4392067
This dryer repair kit consists of five commonly replaced dryer parts: one multi-rib belt (part #661570V and measures 93 1/2 inches long), four drum support rollers, one idler assembly, nine tri-rings, and one washer. This universal maintenance kit is an all-encompassing kit for fixing a noisy dryer, among other symptoms, but noisy being the most common. It is compatible with 27-inch wide dryers built from 1965 onwards. Be sure to disconnect the dryer or shut off the house circuit breaker for the appliance before you begin your repair. To access these parts, you will need to remove the dryer drum. For this installation you will need a 1/4-inch nut driver, a long flat-blade screwdriver, a short flat-blade screw diver, and a Phillips screwdriver.
Fixes these symptoms
- Drum Not Spinning
- Marks left on clothes
- Noisy
- See more...
Your Price
$49.95
Kenmore Dryer Drive Belt
PartSelect Number PS16542496
Manufacturer Part Number WE03X29897
This Drive Belt is 89.5" long and comes in black, featuring four ribs on the inside for a better grip. This is a long belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley, allowing all the parts to work together, spinning the drum as the motor rotates. If the drum will not turn when the dryer is turned on the belt is likely broken. It is common for belts to stretch or become brittle over time, which is what leads to the breakage. If broken, it should be replaced; the drum simply cannot spin without this belt. Refer to your model number and user manual to check if this part is right for you. Ensure you use work gloves to protect your hands from sharp internal parts during this repair. Please note: When comparing the length of your old belt to the length of the belt as stated here, remember that a small amount of stretching and contortion may occur with belts over time for a range of different reasons. Unless your belt is drastically different in length, this belt is what you are looking for despite any small inaccuracies. You will need to remove power to your appliance, remove the main panel, and access the motor drive to slip your new belt back into place.
Fixes these symptoms
- Drum Not Spinning
- Heat stays on after drum has stopped
- Noisy
- See more...
Kenmore Dryer Multi Rib Belt
PartSelect Number PS382430
Manufacturer Part Number 661570
The Drive Belt is a 93 1/2" belt which wraps around the dryer drum to allow tension and movement. If broken the dryer will not turn properly, or there may be loud noises. The part is rated as "medium" difficulty to install. Refer to your model number and user manual to ensure this part is correct for you. To complete this repair you will need a Phillips screwdriver, 1/4 inch nut driver, a putty knife, and a pair of needle nose pliers. Ensure you disconnect your power to the dryer before beginning this repair, which should take between 30 and 60 minutes maximum to complete.
Fixes these symptoms
- Drum Not Spinning
- Noisy
- Won’t Start
- See more...
Kenmore Dryer Drum Belt
PartSelect Number PS1148434
Manufacturer Part Number 134503600
This 88 3/4 inches long and 1/4 inch wide dryer drum belt goes around the dryer drum and the pulley to rotate the drum once the motor is activated.
Fixes these symptoms
- Drum Not Spinning
- Marks left on clothes
- Noisy
- See more...
Your Price
$84.00
Kenmore Dryer Belt
PartSelect Number PS2349294
Manufacturer Part Number 134719300
If your dryer drum has stopped spinning and your clothes are coming out damp, it might be time to replace the belt. This essential part helps the drum rotate, allowing warm air to circulate and dry your laundry properly. Made from sturdy material, it’s built to last but can wear out with frequent use. Replacing it is a manageable DIY project—just grab a screwdriver and wrench to access the belt and swap it out. This part is sold individually, so you’ll only need one to get your dryer running smoothly again.
Fixes these symptoms
- Drum Not Spinning
- Noisy
- See more...
Kenmore Dryer Drum Belt
PartSelect Number PS11705916
Manufacturer Part Number 4400EL2001F
The drive belt is made to wrap around the drum, working with the tension pulley to rotate the drum. If your dryer drum will not turn, then you may need to replace your belt. This drive belt is 1/4-inch wide with 4 ribs and 3 grooves. It is recommended to disconnect the power to your dryer before you start your repair. This drive belt is a genuine OEM part.
Fixes these symptoms
- Drum Not Spinning
- Noisy
- See more...
Kenmore Dryer Drive Belt
PartSelect Number PS4133825
Manufacturer Part Number 6602-001655
Enhance the performance of your home appliances with our Drive Belt, designed specifically for Samsung Dryers, Samsung Washers, Amana Dryers, and Kenmore Dryers. Made to meet the exact design specifications, this authentic component from well-respected brands such as Samsung, Amana, and Kenmore ensures a perfect, secure fit. This Drive Belt efficiently transfers power from the motor to the drum, allowing smooth and efficient operation. It is resilient and durable, crafted to withstand heavy use and prolong your appliance's lifespan. Upgrade your appliance with our Drive Belt for a seamless laundry experience.
Fixes these symptoms
- Drum Not Spinning
- Noisy
- Won’t Start
- See more...
Your Price
$97.03
Kenmore Dryer Drum Drive Belt
PartSelect Number PS11746374
Manufacturer Part Number WP8547157
This part is used to rotate the drum.
Fixes these symptoms
- Drum Not Spinning
- Noisy
- See more...
Your Price
$45.22
Kenmore Dryer Drive Belt
PartSelect Number PS11748749
Manufacturer Part Number WPW10131172
This drive belt is genuine OEM part for your dryer. The belt works with the idler pulley to spin the dryer by driving the drum, and can become worn or break over time. To complete this repair, you will need a screwdriver, putty knife, and socket or nut driver. Accessing the belt involves disassembling the front panel of the dryer. Make sure your new belt is not twisted when installing it on the drum.
Fixes these symptoms
- Noisy
- See more...
Related Kenmore Dryer Parts
- All Kenmore Dryer parts
- Kenmore Dryer Bearings
- Kenmore Dryer Brackets and Flanges
- Kenmore Dryer Caps and Lids
- Kenmore Dryer Circuit Boards and Touch Pads
- Kenmore Dryer Doors
- Kenmore Dryer Drawers and Glides
- Kenmore Dryer Drums and Tubs
- Kenmore Dryer Ducts and Vents
- Kenmore Dryer Elements and Burners
- Kenmore Dryer Fans and Blowers
- Kenmore Dryer Filters
- Kenmore Dryer Fuses
- Kenmore Dryer Handles
- Kenmore Dryer Hardware
- Kenmore Dryer Hinges
- Kenmore Dryer Hoses and Tubes
- Kenmore Dryer Knobs
- Kenmore Dryer Latches
- Kenmore Dryer Lights and Bulbs
- Kenmore Dryer Manuals and Literatures
- Kenmore Dryer Motors
- Kenmore Dryer Panels
- Kenmore Dryer Power Cords
- Kenmore Dryer Pulleys
- Kenmore Dryer Seals and Gaskets
- Kenmore Dryer Sensors
- Kenmore Dryer Springs and Shock Absorbers
- Kenmore Dryer Switches
- Kenmore Dryer Thermostats
- Kenmore Dryer Timers
- Kenmore Dryer Trims
- Kenmore Dryer Valves
- Kenmore Dryer Wheels and Rollers
- Kenmore Dryer Wire Plugs and Connectors