Kenmore Cooktop Switches

Your Price

$107.00

Surface Burner Switch

★★★★★

3 Reviews

PartSelect Number PS12070671

Manufacturer Part Number W11088181

This is the replacement surface burner switch for your range. It measures approximately 1.5 inches by 1.5 inches, with a shaft that is approximately 1 inch long. The surface burner switch turns the surface element on and off and allows you to control how much heat the element produces. The main reason to change the infinite switch is if the switch has shorted out inside, and is not allowing power to the burner, or if the contacts inside are stuck together and the element is stuck on high. Ensure that the burner is off, and the range has been disconnected from the power source before you begin this repair. This part is sold individually and is an OEM part.

Fixes these symptoms

Element will not heat
Will Not Start
See more...

Your Price

$101.14

Surface Burner Switch - 8 Inch

★★★★★

5 Reviews

PartSelect Number PS2342881

Manufacturer Part Number 318293825

This switch controls the large surface burner. As per manufacture the original screws will damage new switch. New screws are needed.

Fixes these symptoms

Element will not heat
See more...

Your Price

$51.18

Burner Switch Kit

★★★★★

3 Reviews

PartSelect Number PS470145

Manufacturer Part Number 5303935086

This switch controls the stove top surface burner.

Fixes these symptoms

Element will not heat
See more...

Your Price

$96.65

Surface Burner Switch

PartSelect Number PS2342883

Manufacturer Part Number 318293827

Fixes these symptoms

Element will not heat
See more...

Your Price

$59.94

Spark Igniter Switch and Harness Assembly

★★★★★

2 Reviews

PartSelect Number PS953094

Manufacturer Part Number WB18T10339

This part is the spark igniter switch and harness assembly for your gas range. This harness assembly has 4 igniter switches already wired into it. It includes the igniter switches and the complete wire harness for all the surface burners. The igniter switches ignite the fuel for your cooktop. If one of the igniter switches has gone bad, you will need to replace the entire assembly. Be sure to disconnect your range from the fuel source before you begin this repair. This is an OEM part sourced directly from the manufacturer.

Fixes these symptoms