Hotpoint Dishwasher Hoses and Tubes

CONDUIT MID Assembly

Pump Filter Coupler

★★★★★

★★★★★

6 Reviews

This coupler, also known as a hose connector, is made of white plastic and is about one inch in height, and just over one inch in length. Replacing the coupler is a fairly easy repair. The hardest part of the repair is accessing the spray arm and filter to remove them, in order to replace the coupler. In order to complete this repair, you will need a flat head screwdriver and a 4-inch nut driver.

Drain Tube Kit This kit includes the drain hose with black rubber end fittings and a clamp.

Drain Hose

★★★★★

★★★★★

1 Review

This drain hose is an OEM, manufacturer-approved replacement part for your dishwasher. The drain hose filters out the wastewater from the dishwasher. If there is a hole in it, water will leak out of your dishwasher. Shut off the water and power to the unit before beginning this repair. Accessing the drain hose involves unscrewing the dishwasher and pulling it out. Remove the clamp holding the hose in place to its connection under the sink, using a 5/16ths socket. Disconnect the fill line. Use a 1/4 inch nut driver to loosen the clamp at the other end of the drain hose. Keep a towel handy for any water still inside. Keep the clamps for use on your new drain hose. Reinstall all hoses and lines in reverse order.

HOSE CHAMBER

★★★★★

★★★★★

1 Review

HOSE CHAMBER

Hose Clamp Kit This hose clamp kit contains two clamps. The smaller of the two is an inch in diameter while the larger of the two is two inches in diameter.

Fill Hose This hose is used to fill the dishwasher with water.

Middle Spray Arm Conduit This part connects and carries water to the middle spray arm.

HOSE FILL