Washer Transmissions and Clutches

Drive Hub Kit

★★★★★

★★★★★

10 Reviews

This drive hub kit (part number W10528947VP) is for washers. Drive hub kit W10528947VP connects the spin basket to the spin shaft that spins the basket. The kit may include multiple parts; refer to your parts diagram for a complete list of parts included. Unplug the washer before installing this part. Wear work gloves to protect your hands.

Washer Drive Pulley

★★★★★

★★★★★

10 Reviews

This is a replacement clutch assembly or cam kit for your washer. The clutch assembly is mounted on the drive shaft on the bottom of your washer. You may need to replace the clutch assembly if the splines on the clutch assembly are stripped and the washer is making noise, or if you are having problems with the wash and spin cycles. You will need to access the bottom of the washer for this repair. It is easiest to if you disconnect your washer from both the water and power source, and lay it on its back. The clutch assembly contains 6 parts, and all are included with the kit. It is also important to change out the entire assembly, rather than individual pieces.

Clutch Assembly

★★★★★

★★★★★

40 Reviews

A worn clutch can cause a slower spin speed which will leave your clothes wet after a cycle. This clutch assembly comes with brake cam driver, blue spring for large capacity washers and black spring for compact washers. As per factory, the blue spring (1.24") replaces the black spring (1.46").

Shift Actuator - 6 Pin

★★★★★

★★★★★

4 Reviews

Basket Hub Kit

★★★★★

★★★★★

22 Reviews

This kit includes one driver hub and two driven basket hubs. The basket hub is located under the agitator. If your washer is not agitating or spinning properly, the hubs will need to be replaced.

Shift Actuator - 120V 60Hz

★★★★★

★★★★★

12 Reviews

This part changes the transmission from agitation to spin mode. This actuator is for washers. Actuator shifts the splutch and monitors the position of the splutch.

CLUTCH

Clutch Housing Assembly with Mode Shifter

★★★★★

★★★★★

1 Review

This clutch housing assembly with mode shifter, or washer drive shaft and shifter assembly, is made for your washer. It connects the appliance wash plate to the motor so the washer can shift the drive system between the appliance spin and agitate cycles. Is measures 14.5 inches in diameter. You may need to replace this part if you hear strange noises or if the washer will not spin or agitate.

Gearcase

★★★★★

★★★★★

3 Reviews

This is used in your direct drive washer that has a neutral drain.

Basket Drive Assembly with Clutch

★★★★★

★★★★★

1 Review

This basket drive assembly is for washers. Basket drive assembly sits on top of the transmission shaft and houses the spin basket brake mechanism. The basket drive spins to rotate the basket during the spin cycle.