Support & Information
Back
Back
Close
Monday to Saturday
8am - 9pm EST
Order Status

Top Appliance Brands

See All >
General Electric Parts General Electric Kenmore Parts Kenmore Camco Parts Camco Frigidaire Parts Frigidaire LG Parts LG KitchenAid Parts KitchenAid Whirlpool Parts Whirlpool Electrolux Parts Electrolux

Top Appliances

See All >
Dishwasher Parts Dishwasher Dryer Parts Dryer Stove Parts Stove Fridge Parts Fridge Washer Parts Washer Microwave Parts Microwave Air Conditioner Parts Air Conditioner Dehumidifier Parts Dehumidifier
Same-day Shipping Truly Canadian 1 Year Warranty 365 Day Returns

Appliance Parts

Shop With Confidence

  1. Visa card
  2. Mastercard card
  3. American Express card
  4. Check PartSelect's Outstanding rating from BizRate and read reviews from customers like you.

Instant Repairman

Enter your model number and our Instant Repairman will help diagnose and fix your appliance

Enter model number

Model number locator Need help finding your model number?

How to replace an icemaker's water inlet valve :

Common icemaker water inlet valve Directions for replacing an icemaker water inlet valve.

Before you begin to replace your icemaker's water inlet valve, make sure you disconnect the appliance's power supply. The easiest way to do this is to unplug the unit from the wall. Alternatively, you could trip the appropriate switch in the circuit breaker panel, or you could remove the appropriate fuse from your home's fuse box.

Consult with an appliance repair technician if you do not feel you have the skill or the ability to successfully complete this repair.

  1. Locate your icemaker's water inlet valve, it is typically located behind a refrigerator. Gently pull your refrigerator away from the wall. You may want to place scraps of carpet, of some other soft material below the fridge to prevent damage to the floor. Turn of the water valve's water supply by closing the shut-off valve in the waterline leading to the water valve. Remove the lower access panel on the back of the refrigerator using a screwdriver or a nut driver.
  2. Place a container under the valve to catch any water that may spill from the water valve and its fill tube. Remove the water valve's fill tubing. Loosen the flare nut on the brass fitting that is found on the inlet side of the water valve. You can use a wrench to loosen the flare nut.
  3. Your water inlet valve is held in place on your refrigerator by means of a metal bracket. Use a screwdriver or a nutdriver to remove the screw that holds the water valve's bracket to the refrigerator cabinet. Gently pull the water valve out of the cabinet, and remove the tube from the outlet port.
  4. There are two wires connecting to the terminals of your water inlet valve. If yours is a double solenoid water valve, it will have four wires. Be sure to label each wire so that you know where to reconnect them later. Firmly grasp the metal connector of the wires in order to remove the wires. You may need to use a pair of needle-nosed pliers. Do not pull on the wires themselves.
  5. Discard the used water inlet valve and proceed to connect the new one. Attach the new valve in the opposite order of what the old one was removed. Replace the rear lower access panel and restore power to your refrigerator. Push your refrigerator back in its spot.