Average Repair Rating: 3.8 / 5.0, 1 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
At power turn-on the dishwasher would start in immediately in the Power Scrub mode and could not be changed or stopped.
I just removed the lower panel according to the manual, but the easier way is to remove the upper control unit by lifting upward. The difficulty with removing the lower panel is that the heavy-duty plastic pieces at the door hinge area are prone to falling out while trying to reattach the heavy lower panel. Replacing the control unit was very easy. All of the connectors have small locks on the back sides. Spreading the plastic locks for the control unit itself lets it come right out. The new unit just snaps in. Just be sure each connector plug is seated and locked. It takes longer to describe it than to do it.
Other Parts Used:
William from MURPHYS, CA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
1 personfound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
6 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Bob
January 9, 2018
My dishwasher starts at the 13 min point for every cycle selected. It runs down to 1 min and remains. I does not go through the normal cleaning cycles. I assume that the control board is the problem. Is that a reasonable thought?
For model number SHU5315UC/11
Hi Bob,
Thank you for your question. If the cycles on the washing machine are not running their full cycle, then you will need to check the main control board, the control panel and the wiring between them to see which part is causing the issue. I hope this helps. Thank you and have a great day!
4 people found this helpful.
Was this helpful?
Thank you for voting!
Michael
July 20, 2021
Shorted a wire while replacing water inlet valve. Dishwasher will not come on. Any fix for it? Thank you
For model number SHV4303uc/u11
Hello Michael, Thank you for the question. When the wire shorted it may have damaged the control board, PartSelect Number PS8717918. We looked up the part and it is listed as No Longer Available/Discontinued sorry. There are no part substitutions listed. Our suggestion here would be to call the manufacturer and see if they can provide you with a substitution for these part numbers and contact us back with he updated substitution number. We hope this helps!
Three of the buttons stopped working. They will not spring back. Does not feel like a button anymore. Is that the control board that springs it back or does the button face have the spring?
For model number SHU5312UC/06
Hi Serge,
Thank you for your question. The part that allows the buttons to spring back is part of the housing of the main control board. The housing is sold separately and the part number for it is PS8702019. I hope this helps. Thank you and have a great day!
2 people found this helpful.
Was this helpful?
Thank you for voting!
Mike
October 19, 2017
Will this part solve the problem of continuous run-on? Even the rinse and hold runs past the countdown number on the screen
For model number SHU5312UC-06
Hi Mike, Thank you for the question. Yes the Main Control Board has the timer build it and should fix the problem of the cycles running over or too long. Good luck with the repair!
2 people found this helpful.
Was this helpful?
Thank you for voting!
William
August 17, 2021
When the dishwasher is turned on, it immediately comes up in the power wash scrub mode and starts its wash countdown cycle. I tried pressing the scrub wash and delicate/econ buttons together to cancel, but it does not stop the cycle. Any ideas?
For model number SHU5314UC/U06
Hello William, thank you for your question. We have researched the model you have provided, and we suggest replacing the main control board, part number: PS8702141. Good luck with your repair!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Mealik
June 21, 2023
My Bosch Dishwasher ecosense SHX5AL05UC
is not draining wwater outside at the end of full cycle. But drain full whil press reset button for 3 seconds.
I have cleaned filter, bottom parts, drainining pipes, and all working and open, fine,. A technitian told me that he beleive there is problem in any computer part ??
Kindly help in diagnosis and how to replace the faulty part,please.
For model number SHX5AL05UC
Hi Mealik, thank you for your inquiry. Based on the description that you have provided, we would recommend checking the control unit, part number PS8735922, as it is the most likely cause of this issue. We are providing you with some general instructions that might help you replace this part:
1) First, unplug the dishwasher.
2) Disconnect the water lines in the back of the dishwasher and take it out of the cabinet.
3) Remove the base panel and disconnect the water line from the front.
4) Now, lay the dishwasher on its left side, remove the insulation and replace the faulty control unit.
Glad to be of help!
Fresh Flow Produce Preserver is made for your refrigerator to help keep produce fresh for longer by absorbing the chemical, ethylene, that causes your fruits and vegetables to ripen quicker. Your produce could be fresh f...
This solid element restorer is for ranges and cooktops. Solid element restorer restores and protects solid elements from rusting and spotting. Follow the instructions on the label when using this product.
This front load washer cleaner removes odor-causing residue. Use it once a month and it will keep your machine fresh and clean. Package comes with 3 tablets.
This low-odor gel, easily cleans away tough burnt-on deposits at room temperature. Apply the gel evenly on the cooled oven surface. Leave the gel to set overnight then wipe away with a clean cloth.
Make your cooktop shine with Frigidaire ReadyClean Glass and Ceramic Cleaner. Our scratch-free, streak-free formula removes smudges, grease, burnt-on food, dirt and oil, while protecting and polishing to repel dust and d...
Model Cross Reference
This part works with the following models:
PartSelect Number: PS8702141
Manufacturer Part Number: 00266746
