GE WD12X10391 - Middle Spray Arm Bracket | PartSelect.ca
Middle Spray Arm Bracket – Part Number: WD12X10391
( Grid squares measure 1x1 inch )
Middle Spray Arm Bracket – Part Number: WD12X10391 Middle Spray Arm Bracket – Part Number: WD12X10391 https://partselectca.azureedge.net/Schematics/GE/00125643i03.gif

Middle Spray Arm Bracket

Your Price

PartSelect Number PS8688153
Manufacturer Part Number WD12X10391
Manufactured by GE

This part works with the following brands: General Electric.

This part works with the following products: Dishwasher.

This part fixes the following symptoms: Not cleaning dishes properly

Customer Repair Stories

Average Repair Rating: 4.4 / 5.0, 2 reviews What's this?
Sort by:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Warren from Stillwater, MN
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers
Parts Used:
WD35X20994, WD28X10391, WD28X25960, WD12X10304, WD12X10054, WD12X10391
Top and bottom rack were rusted thru
Bottom rack - slide the old one out, slide the new one in. The rack came came with the wheels, so I didn't use the replacement ones.
Top rack - remove the rail end caps - they will likely break so order new ones. Slide the rack out. Remove the rotating spray arm and then remove all the brackets. I was able to re-use the old brackets and didn't need the replacements. Install the old brackets on the new rack, install the spray arm, and slide the new rack back into the rails. The new top rack also came with wheels installed, so I didn't use the replacement ones. Once the rack is back in the rails, install new rail end caps. Put them in sideways and facing into the washer. Straighten the caps and turn them into place. Be careful with the rail caps - they break easy and are expensive. Make sure they hold the top rack in place, and that's it.
29 of 41 people found this instruction helpful.
Was this instruction helpful to you?
Joel from Temple, TX
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver
Parts Used:
WD02X10169, WD22X10046, WD12X10352, WD12X10054, WD12X10391, WD12X10052, WD02X10067
the spray arm was off and without brackets
I looked at the diagram on the web site, the same one that I ordered from, and figured out how all the parts were suppose to go together. The spray arm has 2 brackets so it was a matter of aligning the tube that feeds the spray arm with the supply line on the back of he dishwasher. I had to move it once to get it properly aligned but found it to be simple.
7 of 21 people found this instruction helpful.
Was this instruction helpful to you?