Manual,Service

disassembled the top and front installed the shipping bolts in the tub back housing, removed the rear bolt on the stator and removed the shell the magnets have some strong pull, had to split the plastic inner tub in half, removed the 2 lower front shocks and then removed the inner drum,, both bearings and the seal were bad, drove out inner bearing and seal with bearing driver about 2 ft. long and then drove out the rear bearing, cleaned bore and installed new bearings and seal, the spider on the back of the inner drum was damaged from rust damage in the seal area, replaced with new part and reassembled the hardest thing was the 2 side springs, broke one of the plastic noise brackets will order another, got the rest of the washer back together , will install the top after replacing spring noise bracket., block of wood and car spring pliers for rear brakes would probably be easier for the spring install. .Took about 6 hours to disassemble and install new parts. The repair manual was ok for top and front disassembly but no further info on removing the other parts. Used common sense for the rest, used to repair garbage trucks.