Part Location Diagram of WR60X10300 GE Evaporator Fan Motor Assembly
See part 32 in the diagram
( Grid squares measure 1x1 inch )
Customer Service Representative

Get in touch, we're here to help!

Monday to Saturday
8am - 9pm EST

customerservice@partselect.ca

Evaporator Fan Motor Assembly

★★★★★
★★★★★
1 Review
$212.51
  Special Order
PartSelect Number PS2359960
Manufacturer Part Number WR60X10300
Manufactured by GE
Product Description

Evaporator Fan Motor Assembly Specifications

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.
How Buying OEM Parts Can Save You Time and Money

How Buying OEM Parts Can Save You Time and Money

Troubleshooting
This part fixes the following symptoms:
Fridge too warm
This part works with the following products:
Refrigerator.
This part works with the following products:
General Electric, Kenmore.
Part# WR60X10300 replaces these:
AP4413164, 1535877, WR60M0132, WR60M0134, WR60M132, WR60M134, WR60X10069
Back to Top
Customer Reviews
Average Rating:
★★★★★
★★★★★
1 Review
5.0
Filter By Rating:
  • 5 Stars
    1
  • 4 Stars
    0
  • 3 Stars
    0
  • 2 Stars
    0
  • 1 Star
    0
  • 1
Sort by:
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
  • 1
Customer Repair Stories
 Average Repair Rating: 3.6 / 5.0, 3 reviews. What's this?
  • 1
Sort by:
Sorry, we couldn't find any existing installation instruction that matched.
Refrigerator wasn't cooling.
I checked the compressor and it was running. Next I removed the doors amd screws that held the divider strip. Next removed the bottom of the freezer to expose the evaporator fan. Removed the fan and checked it out with volt ohm meter. Discovered the fan motor was out. Ordered new one on line and received thenext delivery day. Insatlled in reverse of disassembly. When I plugged it in everything worked fine. Thanks for the quick delivery. You provided fine service.
Sincerely,
Joe Sutphen
Other Parts Used:
  • Joe from Hallsville, TX
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers, Wrench set
45 of 75 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Frige evaporator fan became noisy then quit working & frige compartment became warm
Came home one evening and found the refer compartment evaporator fan making a noisy/grinding noise. While waiting for the part to arrive the motor finally quit working and the frige lost its ability to cool, but the freezer still worked fine. This is the fan that is inside the frige between the refer & freezer compartments - NOT the fan motor that is located in the bottom/rear next to the compressor. This grinding noise sounded like it was coming from inside the frige and could be easily heard under the vegetable trays and above the freezer compartment. To access this motor you need to go after it from inside the bottom of the frige compartment - there's NO need to remove the refer door. Pull the vegetable trays and remove the small phillips head screw located down in the lower air flow groove toward the front of the refer. Next, pry up & out the front white trim piece that runs the width of the frige. Once that piece is removed you can lift & slide back the whole lower frige trim/tray. Now lift out the large foam block compartment and you'll have complete access to the evaporator fan motor and the evap coils. Simply pull the fan motor assy out, still attached to the triangular bracket and disconnect the electrical pigtail. Next, pull the fan blade straight off the front hub, split & disassemble the motor bracket, & replace both fan motor grommets. Reverse the steps to reassemble the fan motor to the bracket and reinstall back in the bottom of the frige and plug in the electrical pigtail - the fan should (quietly) fire off instantly and begin the cooilng process. Reinstall the foam block, lower frige tray, front trim piece, reattach the phillips screw, close the door, and give it some time - it took our frige overnight to completely cool down. This is not a tough job, I spent more time figuring out how to access the motor then the actuall replacement. Hope these steps help to speed up your repair! And remeber Red Sox 4 Life!
Other Parts Used:
Fan Motor Grommet
  • Scott from Bonney Lake, WA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Loud motor noise emanating from inside the refrigerator (not the compressor or external fan).
My GE GDS18SBPBLSS is now 21 years old (they do not make them like they used to) so I took extra time to not break any of the brittle old plastics. For this replacement you will only need a Phillips head screwdriver.

Parts list:
2 x PS284959 Fan Motor Grommet
1 x PS2359960 Evaporator Fan Motor Assembly

• The first thing you want to do is to unplug the unit refrigerator to prevent any shorts or the fan from starting while you are handling it.
• The evaporator motor is in the refrigerator section, so leave the freezer door shut to preserve the temperature.
• Open the refrigerator door as much as possible and take out the two vegetable/fruit drawers. If your door is right next to a wall and you cannot open it more than 90 degrees, take the drawer furthest from the door hinge first. Then take out the remaining drawer and gently shimmy the center plastic rail guide to allow you to take it out diagonally.
• The front lip of the floor of the refrigerator is clipped in, so pull the plastic trim forward to remove it. If it does not move, lift the center of the plastic trim piece in front of the screw a bit to convince it loose, but it prying it upwards is not advisable because the ends are under the side walls.
• Once the trim piece is removed, remove the Phillips head screw.
• Pull the plastic floor of the refrigerator towards the front and then up to remove it.
• A large foam block secured down with tape needs to be removed next. Once the tape is loosened, lift the foam out carefully with vapor barrier attached under it. Watch for the two foam pieces at the back wall on each side. If they fall off and drop, find them in the freezer later.
• The fan assembly and bracket will be in view, and my suggestion is to take a photo. This way, you know how it should look when it comes time to reassemble everything.
• To the left rear is a small foam block that is taped down. Removing that will reveal the connector clip for the fan motor’s power line that you squeeze the sides to disconnect. Pull the motor wire out of the foam guide.
• Lift the motor bracket assembly out – it is not attached to anything and sits on the foam block.
• Carefully pull the fan blade off by pulling it straight along the motor shaft.
• Undo the rear motor bracket by unscrewing the two Phillips head screws – the right rear motor bracket screw holds the wire guide in. When undone, take the guide off the wire.
• Once the rear bracket is removed, discard the two motor grommets and the motor.
• Put in the new motor with the new motor grommets into the bracket and screw in the left rear screw.
• Clip on the wire guide on to the new motor wiring and then finish mounting the motor with the right rear screw with the wire guide in place.
• Clean off the fan blade thoroughly before pressing into the shaft. Once on, spin the fan to see if it rotates smoothly and easily. Note: Avoid pressing the fan blade too far down as you do not want it to contact the grommet.
• Place the assembly back into the foam block – use the photo from before as a guide if needed.
• Route the motor cable through the foam groove and clip it into the power connector.
• Plug the refrigerator back in to see if the fan spins and to see that there are no issues. If there are no problems, unplug the unit again and continue the reassembly.
• Place the small foam block back into the rear left to cover the connector area.
• While making sure the vapor barrier is positioned correctly above the coils, put the foam block back into place.
• Clean the plastic floor of the refrigerator and then slide it into place, making sure the back and side are flush. Use the screw hole to align the floor properly and then screw the Phillips head screw back in.
• Clean the front trim piece and then slide it back into place.
• Put the drawers back in.
• Plug the refrigerator back in and leave the door closed for a while so the unit cools the internal temperature back down.
Other Parts Used:
Fan Motor Grommet
  • Chong from NEW YORK, NY
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • 1
Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

5 questions answered by our experts.
  • 1
Sort by:
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Roger
November 21, 2017
My freezer is cold but the refrigerator section is not that cold.
For model number GDS18LBR/GDS18SBR
PartSelect logo
Hi Roger, Thank you for your inquiry. If the refrigerator is too warm, there are some parts that you will need to check to see which one is causing the issue. You will need to check the defrost timer, the evaporator fan motor, the fan blade, the defrost thermostat and the overload and start relay. I hope this helps. Thank you and have a great day!

4 people found this helpful.

Was this helpful?
Thank you for voting!
William
November 22, 2019
Hi, how do i get to the evaporator fan motor assembly to replace it.I know where it is from the diagrams but i am not sure how to get to it. I have the doors off but i am stuck there.
For model number pda18lbmalbs refrigerator
PartSelect logo
Hi William, please watch our video here https://www.youtube.com/watch?v=r7zEunxy70Y . Thank you for your question and good luck with your repair!

3 people found this helpful.

Was this helpful?
Thank you for voting!
JP
July 29, 2021
How to change evaporator fan motor!!
For model number PDA18LZMAWW
PartSelect logo
Hi JP, Thank you for the question. Please watch our video here on how to replace the Fan motor. https://www.youtube.com/watch?v=r7zEunxy70Y . Thank you for your question and good luck with your repair!

1 person found this helpful.

Was this helpful?
Thank you for voting!
Josh
January 20, 2018
The freezer works but the fridge does not. The fridge was noisy for a few days every 30 minutes or so (sort of like a loud ticking or like a dry water pump). Then the noises stopped and the fridge no longer cools. I am hoping the noisy symptom will help narrow down the parts to check! Can you help?
For model number GBS18HBMBWW
PartSelect logo
Hello Josh, Thanks for your question. The evaporator fan motor may be at fault in this situation. It can be tested with a multimeter to see if it has continuity. Replace it if it shows no continuity. Check the fan motor grommet as well to see if it is intact. I hope this helps.

Was this helpful?
Thank you for voting!
Related Parts:
Paul
September 11, 2017
My fan runs but constantly has trouble freezing over and the fan gets stuck in the ice,fridge works when it is not in ice.
For model number GDS18SBRALSS
PartSelect logo
Hi Paul, Thank you for the question. Sounds like the appliance is not going through the defrost cycle properly. I suggest replacing the Defrost Timer. Hope this helps!

Was this helpful?
Thank you for voting!
Related Parts:
  • 1
Related Parts
Model Cross Reference
This part works with the following models:
PartSelect Number: PS2359960
Manufacturer Part Number: WR60X10300
Brand
Model Number
Description
General Electric
31261-1
Refrigerator
General Electric
31261-2
Refrigerator
General Electric
31261-3
Refrigerator
General Electric
31269-1
Refrigerator
General Electric
31271-1
Refrigerator
General Electric
31271-2
Refrigerator
General Electric
31271-3
Refrigerator
General Electric
31291-1
Refrigerator
General Electric
31291-2
Refrigerator
General Electric
31291-3
Refrigerator
General Electric
31296-1
Refrigerator
General Electric
31296-2
Refrigerator
General Electric
31299-1
Refrigerator
General Electric
31299-2
Refrigerator
General Electric
31341-1
Refrigerator
General Electric
31361-1
Refrigerator
General Electric
31361-2
Refrigerator
General Electric
31371-1
Refrigerator
General Electric
31371-2
Refrigerator
General Electric
31391-1
Refrigerator
General Electric
31391-2
Refrigerator
General Electric
31396-1
Refrigerator
General Electric
31396-2
Refrigerator
General Electric
31399-1
Refrigerator
General Electric
31399-2
Refrigerator
General Electric
31461-1
Refrigerator
General Electric
31491-1
Refrigerator
General Electric
31496-1
Refrigerator
General Electric
31499-1
Refrigerator
General Electric
3220-00L0S00-B
Refrigerator
Customer Service Representative

Get in touch, we're here to help!

Monday to Saturday
8am - 9pm EST

Contact Customer Service