Heating Element - 240V

I removed front cover of dryer and found heating unit. I needed the detailed drawings from the PartSelect web site to help me find how to get the front cover off. It was easy after that changing out the sensors and reinstalling the heating unit.

First I removed the two screws from the dryer front cover (located just under door)I Then swung font cover up and off it's latches. Exposing drum asy and heating element. Using a nut driver to remove two hold down screws and disconnect electrical wires from heating element. Really simple! took me approxmatly 20 minutes and this included vacuuming inside motor area with a shop vac.

Knowing most mfgs. put prints under the conturo panal we started there.
Diagonstics required a multi meter.
The part was removed and the internet serched.
My local parts center was more expensive and would have to order the part. I called Partselect
found exactly what i needed. placed the order with 3 to 5 day ground. Fedex arived the next day. The new part was installed and the dryer smoke tested. The dryer works great.

I ordered two parts for my Maytag model MDE7400ATW, and studied the videos on your website. Both showed front panel access by removing screws on the bottom of the panel. My front was completely different. It seems both configurations bear the same model number.
I thought I had the wrong parts, then I looked for other videos on the website related to other parts replacement and found that some did have the same cabinet as mine, such as the idler wheel, Part Number WP6-3700340
They should make it clear on the website that there are two cabinet configurations and customers may have to look at the videos for other repairs to learn the correct way to take off the front panel. It may save returns from customers who simply can’t open the front.
After all, the repair went well, but the screw holding the heater assembly in the rear is a long reach and I needed a flashlight to see wher the screw needed to go.