Part Location Diagram of WPW10531320 Whirlpool Drain Pump
See part 14 in the diagram
( Grid squares measure 1x1 inch )
Customer Service Representative

Get in touch, we're here to help!

Daily 8am - 9pm EST

customerservice@partselect.ca

Drain Pump

★★★★★
★★★★★
15 Reviews
$88.06
  In Stock

Get this part fast! Average delivery time for in-stock parts via standard shipping: 1.8 days.

PartSelect Number PS11756031
Manufacturer Part Number WPW10531320
Manufactured by Whirlpool
Troubleshooting
This part fixes the following symptoms:
Not draining | Noisy | Leaking
This part works with the following products:
Dishwasher.
This part works with the following products:
KitchenAid, Jenn-Air, Whirlpool, Kenmore.
Part# WPW10531320 replaces these:
AP6022694, W10314713, W10531320, WPW10531320VP
Back to Top
Customer Reviews
Average Rating:
★★★★★
★★★★★
15 Reviews
4.9
Filter By Rating:
  • 5 Stars
    13
  • 4 Stars
    2
  • 3 Stars
    0
  • 2 Stars
    0
  • 1 Star
    0
  • 1
  • 2
Sort by:
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
  • 1
  • 2
Customer Repair Stories
 Average Repair Rating: 4.6 / 5.0, 5 reviews. What's this?
  • 1
Sort by:
Sorry, we couldn't find any existing installation instruction that matched.
Drain pump flange broke
Laid on my side amd reach under unit
Other Parts Used:
  • Paul from CANONSBURG, PA
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    15 - 30 mins
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dishwasher wasn't draining
Took minutes to repair. Unhooked the electrical plug connector to the drain pump. 1/4 turn to the left and pump was off. Just the opposite to install new pump
Other Parts Used:
  • James from NEW BERLIN, WI
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dishwasher was making a moaning sound when draining.
Unplug dishwasher. Remove lower front accessible panel. Disconnect wires to the drain pump. Rotate pump to unlock and remove. Apply plumbers grease to rubber seal and install new pump. Connect wires. Plug in dishwasher and run rinse cycle to check for no water leak. If all okay replace access panel. Done.
Other Parts Used:
  • Douglas from SAINT JOHN, IN
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver, Pliers
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The drain Pump failed
Took the kick plate off without removing the the machine.
Reached in and turned the existing pump to loosen it. Then disconnected the wire.
Reversed the process to install the new pump.
Other Parts Used:
  • paula from ASHEVILLE, NC
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
We found pieces of glass in the drain pump
Our new drain pump arrived with 2 clips broken. So we switched the housing with the old pump and installed
Used youTube video for step by step instructions
Other Parts Used:
  • Kathleen from DUBLIN, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Socket set
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • 1
Questions and Answers

Ask our experts a question about this part and we'll get back to you as soon as possible!

7 questions answered by our experts.
  • 1
Sort by:
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Stephen Black
November 27, 2018
I'm considering replacing the drain pump on this dishwasher as it has stopped draining and so does not complete the cycle....it just stops and shuts down. There is a clicking noise that happens intermittently when the machine is trying to drain. Does this sound like the pump to you? I have checked the drain hose and it is not blocked. Do you have assembly drawings that show what all the numbered parts in the diagram are? Thanks in advance
For model number KUDEA48FXSS6
PartSelect logo
Hello Stephen, Thank you for the question. The clicking sounds like the control board trying to send the signal to the defective pump to start. If you enter the model number into the site and click on the 9th diagram, it will show all the parts. Hope this helps, good luck with this repair!

6 people found this helpful.

Was this helpful?
Thank you for voting!
Carmen
September 13, 2019
The dishwasher is washing well and even drains. Right after it drains it starts to make a really loud noise off and on. It won't do anything else with the cycle and then eventually just turns off. Does this sound like the drain pump?
For model number KDTE254ESS1
PartSelect logo
Hi Carmen, thank you for your question. Yes, it sounds like you might want to check your drain pump for being the problem. I hope that helps. Good luck with your repair.

1 person found this helpful.

Was this helpful?
Thank you for voting!
David
June 26, 2019
My drain pump is not responding, i am ordering a new one should i replace any related parts at the same time ie drain hose etc Thx
For model number KDTE254ess1
PartSelect logo
Hello David, thank you for writing. You may also want to consider the Drain Hose part PS2358130 and the Drain Hose part PS11756139 for your model.

Was this helpful?
Thank you for voting!
Brian
December 11, 2018
My dishwasher will not start the clean cycle. There is standing water in the base of the wash area. It is making an intermittent clicking/grinding sound a few times then it goes into cancel/drain mode before turning itself off. Does this mean the drain motor is jammed/failed?
For model number JDB8200AWS1
PartSelect logo
Hi Brian, Thank you for your question. If you have standing water in the bottom of your dishwasher, there is likely food debris trapped in the filter or the pump preventing the water from draining. You will need to inspect these parts and clean them of any debris. I hope this helps. Thank you and have a great day!

Was this helpful?
Thank you for voting!
Arthur
August 10, 2021
I have a small amount of water standing in the filter bowl. The dishwasher smells, does not clean well, and does not complete the drying cycle. Any thoughts? I assume the pump is not working properly clearing the dirty water
For model number KDTE334GPS0
PartSelect logo
Hello Arthur, Thank you for the question. The first thing we suggest trying to cleaning the filter, pump and hoses to be sure there is no debris slowing the draining processes and leaving water behind. We hope this helps!

Was this helpful?
Thank you for voting!
Bruce
October 5, 2021
My dishwasher would not drain no noises, cleaned the drain filter and put it back. Ran the dishwasher with no dishes in it and it drained very good. Put dishes in and ran it the 2nd time and did not drain. I removed all water, cleaned everything, put liquid plumber in dishwasher and garbage disposal have not run yet to see results.
For model number KDTE254ESS3
PartSelect logo
Hello Bruce, Thank you for the question. If the Liquid Plumber does not fix the issue, we suggest checking the drain pump and hose for any blockage or clogs. If they are clear, you may have a defective Drain Pump. You can also check the Sump for any blockage as well before replacing the Pump. We hope this helps!

Was this helpful?
Thank you for voting!
Related Parts:
Wally
June 21, 2022
I would like to know if we can get a replacement impeller for the drain pump rather then replacing the entire pump since the pump is still working? Thanks
For model number JDB8700AWP3
PartSelect logo
Hello Wally, Thank you for the question. Very sorry, the parts to the Pump are not sold separate from the Pump. Whirlpool only sells the impeller as part of the Drain Pump Assembly. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!

Was this helpful?
Thank you for voting!
Related Parts:
  • 1
Model Cross Reference
This part works with the following models:
PartSelect Number: PS11756031
Manufacturer Part Number: WPW10531320
Brand
Model Number
Description
Kenmore
66512762K312
Dishwasher - Dishwasher
Kenmore
66512763K313
Dishwasher - Dishwasher
Kenmore
66512769K313
Dishwasher - Dishwasher
Kenmore
66512773K313
Dishwasher - Dishwasher
Kenmore
66512773K314
Dishwasher - Dishwasher
Kenmore
66512776K311
Dishwasher - Kenmore Dishwasher Model 665.12776K311 (66512776K311, 665 12776K311) Parts
Kenmore
66512782K310
Dishwasher - Dishwasher
Kenmore
66512782K312
Dishwasher - Dishwasher
Kenmore
66512782K313
Dishwasher - Dishwasher
Kenmore
66512783K311
Dishwasher - Undercounter Dishwasher
Kenmore
66512783K312
Dishwasher - Dishwasher
Kenmore
66512783K313
Dishwasher - Dishwasher
Kenmore
66512789K311
Dishwasher - Undercounter Dishwasher
Kenmore
66512789K312
Dishwasher - Dishwasher
Kenmore
66512789K313
Dishwasher - Dishwasher
Kenmore
66512793K312
Dishwasher - Dishwasher
Kenmore
66512793K313
Dishwasher - Dishwasher
Kenmore
66512833K311
Dishwasher - Kenmore Dishwasher Model 665.12833K311 (66512833K311, 665 12833K311) Parts
Kenmore
66514753N510
Dishwasher - Dishwasher
Kenmore
66514753N511
Dishwasher - Dishwasher
Kenmore
66514753N512
Dishwasher - Dishwasher
Kenmore
66514754N510
Dishwasher - Dishwasher
Kenmore
66514754N512
Dishwasher - Dishwasher
Kenmore
66514793N512
Dishwasher - Dishwasher
Whirlpool
BLB14DRANA0
Dishwasher
Whirlpool
BLB14DRANA1
Dishwasher - UNDERCOUNTER DISHWASHER
Whirlpool
BLB14DRANA2
Dishwasher - DISHWASHER
Whirlpool
BLB14DRANA4
Dishwasher - DISHWASHER
Whirlpool
BLB14DRANA5
Whirlpool
BLB14FRANA0
Dishwasher
Customer Service Representative

Get in touch, we're here to help!

Daily 8am - 9pm EST

Contact Customer Service