Coupler and Hose Assembly WP99001868

Turned machine on side. Removed two casters with Wonder Tool prybar. Then used it to remove plastic push screws holding cardboard bottom cover. Unscrewed water hose. Used screwdriver to remove clamp on drain hose. Stood machine upright, opened door. Unscrewed two screwsfrom tabs into woodblock top. Slid top forward and removed it. Cut plastic hose retainer. Removed hose assembly. Installed new hose by reversing steps. Used a new wire strap to hold hoses in place on top corner of machine.

tilted the dishwasher back so the bottom was exposed and unhooked the old hoses, then removed old hoses through the back side of the dish washer then fed the new hoses through the back and hooked them up.

I turned the dishwasher on its side, exposing the bottom. You can visibly see where the two hoses connect to the dishwasher - one is secured via worm gear hose clamp (screw driver removal), the other simply screws on.

Be prepared for residual water leakage once these hoses are removed. Either lay towels out, or find a way to fully drain the hoses. Pay attention to how the hoses are fed through the back of the dishwasher so you can repeat this with the new hoses.

The new hoses are fed through the hole on the back of the dishwasher, run along the inside of the back panel, and fed out the bottom of the dishwasher. Reconnect the hoses, secure the one hose with the hose clamp, and you're good to go.