This electronic control board is for refrigerators.
The electronic control board manages the functions of the refrigerator such as cooling and defrost times.
Safely store any food that could deteriorate while the power is off and unplug the refrigerator before installing this part. Wear work gloves to protect your hands.
How Buying OEM Parts Can Save You Time and Money
Troubleshooting
This part fixes the following symptoms:
Fridge too warm
This part works with the following products:
Refrigerator.
This part works with the following products:
Frigidaire, Crosley.
Part# A01078804 replaces these:
242207704, 242282304, 5304498023
Customer Repair Stories
Average Repair Rating: 3.0 / 5.0, 2 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Evaporator coil and fan frozen; fault code HI
The fault code HI or H1 would periodically appear. Evap coil and fan would freeze over. I replaced evap fan motor, run capacitor, defrost thermostat, and temp sensor with no luck. I know Evap heater worked because I burnt my fingers on it. I noticed when I tapped on the front of the control panel to reset the fault, the evap fan would turn on. I assume the relay in the control board was intermittently faulty. I replaced the board and my fridge is good to go, finally.
Other Parts Used:
Clifford from VIRGINIA BCH, VA
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver
10 of 12 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Double door. Refrigerator control panel displayed HI [temp 55*f or higher]
I bought and replaced the control board as suggested. It didn't help. It was suggested that it was the Damper [lets cold air from the freezer into the refrigerator side]. I bought a new Damper unit. It didn't help. It was suggested that I replace the temp sensor[s]. I replaced them both, and the HI alert disappeared, but it did not help with cooling the refrigerator. I gave up after spending $400 on parts with no solution; I bought a new double-door refrigerator. Note .... None of these parts come with any instructions. You have to watch youtube.
Other Parts Used:
Billie from ROGERSVILLE, MO
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver
3 of 4 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
20 questions answered by our experts.
< Prev
1
2
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Dan
October 7, 2019
The digital readout keeps going back to hi for the refrigerator side. The refrigerator will not cool down. We turn it up to 4 or 5 or 6 and within a short time the beeper goes off and when you open up the door the setting has gone back to 1 and hi. The freezer side works fine? Do i need a new board?
For model number FFHS2611PFEA
Hello Dan, thank you for inquiring. You will want to consider this as either a faulty Evaporator Fan Motor, part number PS12728811, or Defrost Heater, part number PS2581596 for your model. Good luck with your repair!
6 people found this helpful.
Was this helpful?
Thank you for voting!
CJ
June 19, 2019
My freezer is over freezing everything and the refrigerator is barely keeping cold, as well as doing 3 beeps about every 20 seconds or so. I pulled off the back panel and the coil has a lot of ice on it. Should i change the defrost control board?
For model number FFHS2311PFBA
Hello CJ, thank you for inquiring. This sounds like the Defrost Thermostat Kit part PS469522 for your model is faulty. We hope this helps.
5 people found this helpful.
Was this helpful?
Thank you for voting!
Corinne
February 9, 2020
My freezer and fridge will not get cool it is doing the five beeps as if the door is open and the freezer side is flashing high? Is it the control? or door switch?
For model number FFSS2614QS4A
Hi Corinne, thank you for your question. When you are having temperature problems in your appliance, there are a few parts that could cause the issue. You can use a multi meter to test most of the parts. Make sure you cut power to your appliance before doing any repairs or tests. First you should test your defrost thermostat. Place the thermostat in ice cold water for 2-3 minutes after removing it from your appliance. It should be reading 0 ohms to be working correctly. Another part to check would be your defrost heater. Remove it from the appliance. It should be reading anywhere between 0 - 50 ohms to be working. You could check your temperature sensor. To find the correct reading for this part you will have to refer to your tech sheet that comes with your appliance. You can usually find this tech sheet behind the bottom grille of your fridge on either the right or left side. These are the most common parts that cause this issue in your appliance. So it is suggested you check them first. Good luck with your repair.
3 people found this helpful.
Was this helpful?
Thank you for voting!
Mickey
June 21, 2019
If i set. Both refrigerator and freezer at five and a little while longer it will drop down to one on its own does not matter what number i set it out what would be the problem
Hi Mickey, thank you for your question. When you are having temperature problems in your fridge, there are a few parts that could cause the issue. You can use a multi meter to test most of the parts. Make sure you cut power to your appliance before doing any repairs or tests. First you should test your defrost thermostat. Place the thermostat in ice cold water for 2-3 minutes after removing it from your appliance. It should be reading 0 ohms to be working correctly. Another part to check would be your defrost heater. Remove it from the appliance. It should be reading anywhere between 0 - 50 ohms to be working. You could check your temperature sensor. To find the correct reading for this part you will have to refer to your tech sheet that comes with your appliance. You can usually find this tech sheet behind the bottom grille of your fridge on either the right or left side. These are the most common parts that cause this issue in your appliance. So it is suggested you check them first. I hope that helps. Good luck with your repair.
1 person found this helpful.
Was this helpful?
Thank you for voting!
ED
April 24, 2018
Refrigerator turned to coldest setting.Temp fluctuates between 37 and43 degrees changed defrost thermostat that was not the problem.Should i try the control board next?
For model number FFHS2611LBK
Hi Ed,
Thank you for your question. If the temperature is fluctuating in the refrigerator, there are some parts that you will need to check to see which ones are causing the issue. You will need to check the run capacitor, the defrost heater, the sensor, the gaskets and the electronic control board. I hope this helps. Thank you and have a great day!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Shana
April 4, 2019
My fridge is freezing everything and also the freezer is stuck on 9 on the temperature control. The up arrow will beep, but the down arrow won't do anything. Could this be what's causing the fridge to freeze?
For model number FFHS2611LBNA
Hello Shana, Thank you for the question. Yes, the most commonly replaced part would be the control board, PartSelect Number PS10060580. This board controls the temperature. Thank you for your inquiry, good luck with this repair!
1 person found this helpful.
Was this helpful?
Thank you for voting!
David
June 6, 2023
Refrigerator and freezer are cooling but if I turn them up to 7,8, or 9 the control board turns off and beeps 3 times. It then comes back on but both the refrigerator and freezer are set at 5.
For model number FFSS2314QE5A
Hello David, thank you for reaching out. You may need to check the electronic control board, part number PS10060580, to fix the issue. The electronic control board manages the functions of the refrigerator, such as cooling and defrosting times. Glad to be of assistance!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Ernie
Today
The fridge does not have power! I checked the breaker and connected it to another working outlet. No lights and no display on the panel.
What is the most likely problem?
For model number LFSS2612TF4
Hello Ernie, Thank you for contacting us. This issue is usually caused by a faulty control board or a wiring issue. Check the wiring harness with power cord PS12728990, the control board wiring harness and control board for any visible damage, and you can test the connectors with a multimeter. Good luck with your repair.
I was getting the h1 code and my freezer was not defrosting. Replaced the thermostat in the freezer and the freezer now is working fine but still getting the h1 and frig does to seem to be cooling. What could be causing this
For model number Ffhs2611lwja
Hello Michael, thank you for getting in touch. The H1 error code usually means that the freezer sensor has shorted. As you have already replaced the freezer sensor, the issue seems to be with the control board, part number PS10060580. Replacing the control board may solve your problem. We hope this information helps!
Was this helpful?
Thank you for voting!
M
November 22, 2023
Hi. Does this control board PS10060580 fit Frigidaire Serial # 4A52404953 model #SS2614QS
For model number Frigidaire FFSS2614QS
Hi M, thank you for your question! The electronic control board that you have mentioned is compatible with your model. We hope this helps.
Was this helpful?
Thank you for voting!
< Prev
1
2
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
Fresh Flow Produce Preserver is made for your refrigerator to help keep produce fresh for longer by absorbing the chemical, ethylene, that causes your fruits and vegetables to ripen quicker. Your produce could be fresh f...
This front load washer cleaner removes odor-causing residue. Use it once a month and it will keep your machine fresh and clean. Package comes with 3 tablets.
This solid element restorer is for ranges and cooktops. Solid element restorer restores and protects solid elements from rusting and spotting. Follow the instructions on the label when using this product.
This low-odor gel, easily cleans away tough burnt-on deposits at room temperature. Apply the gel evenly on the cooled oven surface. Leave the gel to set overnight then wipe away with a clean cloth.
Make your cooktop shine with Frigidaire ReadyClean Glass and Ceramic Cleaner. Our scratch-free, streak-free formula removes smudges, grease, burnt-on food, dirt and oil, while protecting and polishing to repel dust and d...
Model Cross Reference
This part works with the following models:
PartSelect Number: PS10060580
Manufacturer Part Number: A01078804