Multi-Tool Parts

This is a genuine OEM replacement part, it is sold individually. This is part of the clamp assembly that holds the accessories for the tools listed below. It is 3/4" in diameter,beveled in the center,with a 1/4" bore.

This cord is a genuine Makita replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 3 Prongs • 3 Wires • 18 Gauge • 8 Feet Long

This is an authentic OEM approved replacement part designed for Ridgid JobMax Multi-Tool Head. This is a hook and loop fastener closure system. The rough side is called hook. Its softer mate is called loop. The hooks engage into the loop and provide the closure mechanism. This part is made out of metal with plastic and it is sold individually. Please note screws used to attach it to the sander are sold separately. Changing the pad is easy and will only require a hex key/allen wrench. • First remove the screws that secure the pad • Remove old pad and replace it with the new one • Secure it using the screws

It is a genuine item that is supplied by the original equipment manufacturer for use with Makita power tools. This special holder bolt helps to secure an attachment tool to the drive shaft. It provides an identical replacement for a damaged or a missing component that was included with a new unit. To ensure the exact location and the correct application of this hardware, refer to the owner's manual for your model. Keep in mind this high-quality holder bolt is made of durable metal and is sold as an individual item. Replacing it is a simple task that should not require any tools.

This item has been sourced from the original manufacturer and is intended to be used with routers, drywall cut out tools, laminate trimmers, demolition tools, and multi-tools from Makita. The switch is used to relay electricity from the power cord to the tool's motor. This item is sold as an individual replacement part.

This is a genuine manufacturer approved replacement part designed for use with power handles. This is the gear cap for the motor. It is made out of rubber and it is sold individually. To complete this repair you would need a screwdriver.