XWT13ZB Makita Wrench - Overview

This is Makitas Lithium-Ion charging system. This charger uses three controls to ensure the best possible charge: Temperature, Voltage, and Current. These controls are monitored by a chip on the battery, and analyzed by a CPU on the charger. This prolongs battery life, and keeps cordless power tools running at peak performance. There is ...Read morea forced air fan on board the charger, keeping batteries cool while re-charging. A 3.0 Ah battery will charge in less than 45 minutes.

It is a genuine OEM supplied replacement flat washer which has a few different applications depending on the tool, make sure to check appropriate diagrams for correct location and use of this hardware. Please note this part is made from high quality metal and it is sold individually.

This is a genuine item that is supplied directly from the original equipment manufacturer for use with Makita power tools. It is an identical replacement for a missing or damaged rubber pin that was originally installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and applicat...Read moreion of this hardware. Keep in mind this high-quality item is made of durable rubber material and is sold individually.

This replacement tapping screw is sourced directly from original equipment manufacturer. It is specially designed for Makita power tools. It is a standard hardware which has multiple applications based on a tool. Please make sure to check appropriate diagrams for the location and use of this screw. This part is made out of metal and it is...Read more sold individually. Requires a screwdriver to tighten/loosen this screw. This is a self tapping screw can tap its own hole as it is driven into the material.

This is an OEM part sourced directly from the manufacturer. The o-ring is used in Makita demolition hammers and multi-tools. An o-ring is a plastic part designed to seal and pad the connection between two other parts, and there may be many different sizes of o-ring in the same tool. Please refer to the parts diagram to be sure you're o...Read morerdering the correct part. You may require a screwdriver or wrench to replace this part. It is advisable when removing parts to keep careful track of the order they should be in, so they can be replaced correctly. This part is sold individually.

This genuine OEM steel ball is found within the housing of your power tool. It serves as a detent mechanism, securing the shift knob in various positions to allow for the selection of different operating modes. It has a diameter of 4.8mm. If you notice signs of wear or deformation on the steel ball, it is a clear indication that it needs ...Read moreto be replaced. A worn-out steel ball can result in a loose shift knob that fails to hold its selected position properly. To locate and access the steel ball within the housing, refer to the instructions outlined in your user manual. Your tool may use steel balls of different sizes, so confirm that this is the correct part your repair will need before making your purchase.