XRJ07RZB Makita Reciprocating Saw - Overview

This genuine manufacturer-sourced part is specially designed for use with Makita saws. It an identical replacement for a missing or a faulty square nut that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality square nut is made of durable metal and is sold individually.

This is a genuine item that is supplied directly from the original equipment manufacturer for use with Makita power tools. It is an identical replacement for a missing or damaged rubber pin that was originally installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and applicat...Read moreion of this hardware. Keep in mind this high-quality item is made of durable rubber material and is sold individually.

This hex socket head bolt provides secure fastening for tool housings and internal components, helping maintain structural stability during operation. Designed with an M6 × 14 size and durable construction, it is built to withstand vibration and heavy use while ensuring a tight, reliable hold. Replacing a worn or missing bolt helps restore proper assembly and ensures consistent, dependable tool performance.

This item is a genuine Makita part that is OEM sourced to ensure a high level of quality. The switch is intended to be used with cordless drill/drivers. This item fits into the housing just below the motor. The switch is used to relay electricity from the battery to the motor. This item is sold as an individual replacement part.

This replacement tapping screw is sourced directly from original equipment manufacturer. It is specially designed for Makita power tools. It is a standard hardware which has multiple applications based on a tool. Please make sure to check appropriate diagrams for the location and use of this screw. This part is made out of metal and it is...Read more sold individually. Requires a screwdriver to tighten/loosen this screw. This is a self tapping screw can tap its own hole as it is driven into the material.

This is an authentic manufacturer approved replacement part designed for use with Makita reciprocating saws. This part fits in the side of guide sleeve. It is made out of metal and it is sold individually. To complete this repair you would need pliers.

This authentic replacement part which is specially designed for use with Makita power tools. Ball bearings are used to reduce friction between rotating parts, over time components may begin to wear out and fail eventually requiring a replacement. Please note this high-quality ball bearing is made of durable metal and it is sold individually.

This is an authentic Makita replacement part, sourced from the original manufacturer for use with power tools. The special oil seal is commonly used to seal the connection between a spindle or shaft and a gear case housing. This oil seal is available as an individual replacement part, please see model diagram for associative parts.

The ring fits between two different flat washers and is made of rubber. This item is available as an individual replacement part. This is an authentic OEM part for use in Makita saws. It might require a screwdriver to replace this part if it becomes broken.