This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, an...
This is a genuine replacement light bulb for a refrigerator. The inside of your refrigerator should illuminate when you open the door. If your fridge does not illuminate, you may need to replace this ...
This temperature sensor is for refrigerators.
The temperature sensor senses the temperature inside the refrigerator and sends information to the electronic control.
Unplug the refrigerator and s...
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
If your refrigerator or freezer is too warm, or making noises, you may need to replace the fan blade. The fan blade attaches to the evaporator motor, which is in the freezer section, to help circulate...
This is the replacement wire shelf for your refrigerator. It is approximately 12 inches by 25 inches. The wire shelf slides into grooves on either side of the refrigerator and is used to store meat an...
$89.07
In Stock
Questions And Answers for WZF34X16DW00
Ask our experts a question about this model and we'll get back to you as soon as possible!
8 questions answered by our experts.
< Prev
1
2
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
K
October 24, 2022
Not freezing well. Temps only in the 20 s. Noticed bottom air vent is partially iced over. What is the issue
For model number WZF34X16DW00
Hello, thank you for contacting us. We would recommend cleaning the condenser coils and manually defrosting the built-up ice. We would also recommend checking the defrost heater, part number PS11752658, and the temperature sensor, part number PS11753994. Customer service is always available to help you place an order if you are having trouble doing so. Good luck with your repair.
All of a sudden my freezer door opens by it self. Could the door gasket be at fault?
For model number WZF34X16DW00
Hello Peter, Thank you for the question. In most cases this would be caused by a weak gasket. We hope this helps.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Evan
January 21, 2024
need door gasket replacement #, where to order
For model number WZF34X16DW00
Hi Evan, thank you for writing in. Our research has found, part number PS11731151 is the correct Door Gasket for your model. You can place an order on our Website or call our Customer Service Department to place an order. We hope this helps.
I am looking for a owner/parts manual for this freezer. I need to reset the temperature to a lower level. I am hoping that the manual will have this information. Thank you for any help ypu can provide.
For model number WZF34X16DW00
Hello Joel, thank you for your inquiry. Unfortunately we do not carry manuals for model WZF34X16DW00. I apologize for the inconvenience.
Was this helpful?
Thank you for voting!
AL
May 6, 2023
Does this model have a DEFROST TIMER ?
For model number WZF34X16DW00
Hello Al, Thank you for your inquiry. We do not show a timer listed for this model. We hope this helps.
Was this helpful?
Thank you for voting!
< Prev
1
2
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again.
An easy job for smaller hands. Removed the two bolts holding the light cover. Removed two electrical connections from the old switch by pinching the retaining clip,removed the switch, snapped in the new one and re-attached the connectors. Your online illustrations helped me to know that the plastic housing for the light switch would only swing down so far and was not intended to be removed. Saved me from breaking that plastic cover's tabs. This home repair saved me more than 5 times the cost of hiring a professional to do it. Very happy homeowner.
This product comes in a bottle with a brush like Liquid Paper. It goes on incredibly easy. A second coat might be needed. I wanted to prevent rust from setting in so I covered the scratches and dings. The paint is a little brighter since my washer is 10 years old but it still looks great.