Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Ashley
February 10, 2020
I dont have the model number with me at this time but i have a stackable washer dry set and i believe the heating element went out of it but could be wrong cause i have been reading there could be a fuse could you please point me in the direction of which one it is more then likely because the dryer still spins like its trying to dry but it's not getting hot
For model number WSM2420TBAWW
Hello Ashley,
Thank you for your question. Although we can not say where specifically your dryer fuse would be, most of the time it is located near or attached the the fan motor that blows the heat into the dryer, and its more likely a blown fuse that's causing the lack of heat rather then the element itself. We hope this helps.
1 person found this helpful.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Our washing machine had gotten stuck in the agitation cycle several times....it wouldn't cycle out of either wash or rinse, and was clogged with suds. Turns out we were using the wrong detergent, one recommended only for front-loading high efficiency washers. I removed knobs and front panel, then the two screws holding the timer mechanism in. Although it looked nearly new, clearly it didn't work. The replacement part arrived in two days, and was easy to install.- 5 screws holding the panel, and 2 on the timer. tested the washer today, and it worked perfectly.
The agitator broke free while the washer was spinning and it shredded the plastic. All I had to do was remove a little top cap off the agitator by prying it up with a screwdriver, then replacing the cap on the new agitator. Viola! Done. Very easy!
The removal and installation were self-explanatory once the part was in hand. Because the unit is in a laundry closet off the bathroom, space was limited and we had to be creative. Hence, my son's Handy Manny tool set, Turner to be exact, was perfect for holding the ground wire bolt in place from behind the dryer lid so that we could loosen the nut on the inside of the dryer lid. Of course, when I went to put the nut back on the bolt after putting the new ground wire in place, I dropped the nut in the dryer. That's when our son's Harvey the train (a Thomas the Tank engine character) came in handy. My long arms and its magnet were just the thing to get the nut out of the abyss at the bottom of the washer cabinet.
