Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Phoebe
November 2, 2021
Washer working dryer does not is there a safety on dryer that washer being out of balance would shut dryer down? Where do I start?
For model number WSM2420D0WW
Hello Phoebe, Thank you for the question. There is no safety listed. If the appliance is getting power but will not start, we suggest checking the Door Switch. If the Door Switch is defective or an unbalanced load loosened the wires, it will not allow the dryer to start, thinking the door is open. We hope this helps!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Our washing machine had gotten stuck in the agitation cycle several times....it wouldn't cycle out of either wash or rinse, and was clogged with suds. Turns out we were using the wrong detergent, one recommended only for front-loading high efficiency washers. I removed knobs and front panel, then the two screws holding the timer mechanism in. Although it looked nearly new, clearly it didn't work. The replacement part arrived in two days, and was easy to install.- 5 screws holding the panel, and 2 on the timer. tested the washer today, and it worked perfectly.
The agitator broke free while the washer was spinning and it shredded the plastic. All I had to do was remove a little top cap off the agitator by prying it up with a screwdriver, then replacing the cap on the new agitator. Viola! Done. Very easy!
The removal and installation were self-explanatory once the part was in hand. Because the unit is in a laundry closet off the bathroom, space was limited and we had to be creative. Hence, my son's Handy Manny tool set, Turner to be exact, was perfect for holding the ground wire bolt in place from behind the dryer lid so that we could loosen the nut on the inside of the dryer lid. Of course, when I went to put the nut back on the bolt after putting the new ground wire in place, I dropped the nut in the dryer. That's when our son's Harvey the train (a Thomas the Tank engine character) came in handy. My long arms and its magnet were just the thing to get the nut out of the abyss at the bottom of the washer cabinet.