The rack track stop on your dishwasher is designed to stop the dish rack at the appropriate place when opening and closing the rack. If your dishwasher is not cleaning your dishes properly, the rack s...
$9.83
In Stock
Order within the next 12 hrs and your part ships today!
Sold individually. This part secures the upper side of the dishwasher to the underside of the counter or cabinet to prevent the dishwasher from moving, shaking, or tilting forward.
$12.80
In Stock
Order within the next 12 hrs and your part ships today!
This manufacturer-certified heating element is used to create heat during the dry cycle and increase water temperature during portions of the wash cycle when certain options are selected. If your dish...
$84.35
In Stock
Order within the next 12 hrs and your part ships today!
The rinse aid cap (sometimes referred to as the dispenser cap), covers the rinse aid dispenser on the dishwasher door. If your dishwasher will not dispense detergent, or it is leaking detergent, there...
$35.18
In Stock
Order within the next 12 hrs and your part ships today!
This is a lower spray arm for a dishwasher. The lower spray arm allows water to be spread evenly throughout the dishwasher tub with the proper force so dishes come out clean. This spray arm is gray in...
$77.52
In Stock
Order within the next 12 hrs and your part ships today!
This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, an...
$10.20
In Stock
Order within the next 12 hrs and your part ships today!
This water inlet valve should be located behind the lower kick plate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.
$81.63
In Stock
Order within the next 12 hrs and your part ships today!
This is a replacement middle spray arm in your dishwasher. You will find your middle spray arm mounted on the bottom of the middle dish rack. The upper spray arm rotates and sprays water during the op...
$63.68
In Stock
Order within the next 12 hrs and your part ships today!
NOTE: This part has been redesigned, it may appear different but will still function the same as the original.
$56.25
In Stock
Order within the next 12 hrs and your part ships today!
Questions And Answers for WDF530PAYM6
Ask our experts a question about this model and we'll get back to you as soon as possible!
3 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Ken
December 14, 2019
Dishwasher runs through cycle, doesn't drain then shuts off. If you push the cancel-drain button it then drains? Filters are clean,no blockage.Thank you.
For model number WDF530PAYM6
Hi Ken, I would look into replacing the door latch, or control board. Thank you for your question and good luck with your repair!
Dishwasher not draining after full cycle,filters are clean and so is drain. After it completes cycle and shuts down there is still water in the basin, if you then press the "cancel drain" button it will then drain.I purchased a cntrl-elec board from you part# w10597045 this was not the problem,any other ideas?Thank you
For model number WDF530PAYM6
Hello and thank you for writing.
This could possibly indicate a malfunctioning drain pump PS11753379 or in rare cases a faulty turbidity sensor PS11757214. We hope this helps. Please contact us anytime if you require further assistance.
dishwasher just stopped working. nothiing happens when buttons are pressed.
For model number WDF530PAYM6
Hello Christine, thank you for your question. First, check your wiring box. These wires will often short out, melt, or get loose. Check all the connections and if they are faulty or burnt, cut the wires back and re-wire the wiring box (with the power disconnected to the dishwasher of course). If everything checks well, you will need to check the door latch, part number PS8770043. If this is not causing the issue, you may need to replace the control board, part number PS8260226. Before replacing the control board, we recommend you check the heating element, part number PS8260087. Good luck with the repair!
Caviat: The actual repair is less than 15 minutes, but I spent a lot of time playing with it before I figured out it was that easy and fast. You don't need to remove the dishwasher from the counter to do this. And it will probably help to look at the new part closely so you can understand where the retainer clip is to press it and release the old pump.
First remove the water from the dishwasher pan that would not drain with a wet/dry vac. Otherwise the water will all drain on the floor when you remove the pump. Then remove the two screws on the kickplate on the front of the unit below the door. Remove the kickplate/maintainence access cover. The drain pump is on the right about 8 inches in. Using two hands you grasp the drain pump with your right hand and use the left hand to push the retaining clip down. Then the drain pump will rotate 1/4 turn counterclockwise and can be removed without pulling the dishwasher out. There is likely to be some water leak out that was traped in the pump housing that you can not reach with the vac. Disconnect the wire. Connect the wire to the new pump, put it in place and 1/4 turn clockwise to install it. Replace the kickplate and you're done.