Have a wobbly washing machine? Here's a solution that gets you back to effortless laundry days ? the LG Washer Supporter Leg. Thoughtfully designed, this little hero does a big job. It props up your l...
$32.95
In Stock
Order within the next 11 hrs and your part ships today!
Order within the next 11 hrs and your part ships today!
Questions And Answers for WD200CV
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Miki
February 9, 2022
No drainage.
For model number WD200CV
Hello Miki, Thank you for writing. With the information provided, we suggest checking the Drain hoses for any blockage and the pump. If they are clear, you may have a faulty Drain Pump. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!
Our toddler stood on the handle of the pedestal washer - broke it - but we didn't know how much of a problem this was until the washer started to leak. Well, gravity doesn't work backwards, so I started with assuming the door seal was wrong instead of any drains or hoses. Ordered this part (which was perfect by the way) and fixed it right away.
Special note: you DO NOT need additional hinges as the replacement door comes with them already. To replace the hinges, simply push them out from the back side (i.e. opposite end where they are compressed). Installing new ones is easy, almost too easy to where you think it is not enough, but if they are seated and the door operates it is fine.
Exceptionally easy fix. Was able to do it with two sleeping kids under 3 years old never waking up in less than 5 minutes. 100% satisfied.
Disconnect machine from power source. Then, disconnect any tubes from the back side (make sure you close any water valves before doing so). Then, lay the machine on its back to access the bottom of the machine. Then, locate the thermistor and replace it with the new one (the thermistor will have two screws holding it in place, simply remove the screws and replace the thermistor, then screw it back in). After the new part is installed, stand the machine back up and make sure to connect any tubing to its proper place. Done.
Using pliers I applied pressure on the center of white plastic hinge pin allowing me to slide the pin hinge out. I removed the lid, replaced it with the new one and inserted a new pin hinge.
