Ask our experts a question about this model and we'll get back to you as soon as possible!
5 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Dennis
September 14, 2023
I need throttle cable. What is part number.
For model number UT26SSL3VNM
Hi Dennis, thank you for reaching out. The part you are looking for is the throttle cable, part number PS16753620. Glad to be of assistance!
Tension on pull rope lost. Need to reload tension. Nothing broken.
For model number UT26SSL3VNM
Hi Steve, thank you for reaching out. According to our research, this issue is most probably related to the rewind spring, part number PS9987666, you may need to replace it to fix the issue. We hope this sorts out your problem!
I am trying to remove the bump feed housing by rotating counter clock wise because I have a line jam but it won’t turn
For model number UT26SSL3VNM
Hello Dave, thank you for reaching out. We have found that something could be blocking the cap, keeping the line from advancing. To inspect, simply remove and clean out the bump cap housing of any debris that may be impacting its operation. If this is not the issue, we would recommend checking the spool, part number PS16353019, to fix the issue. The spool houses the wound trimmer line, which is located inside the trimmer head. If the line is too thick, it can get stuck and fail to feed; if the line is too thin, it may get overheated by friction when cutting, especially under heavier loads. We hope this solves your problem!
I accidentally removed the cap from the spool and can't put it back on
For model number UT26SSL3VNM
Hi Samantha, thank you for reaching out. Align the knob ribs with the spool slots and place the bump knob onto the spool. Insert the bump knob and spool assembly through the opening in the string head housing. Align the slots on the lower string head housing with the tabs on the upper string head housing. Push the housing together until the tabs snap into place. Hold the spool by the knob while completing the installation. We hope this solves your problem!
Was this helpful?
Thank you for voting!
Donald
August 17, 2023
Bump head continuously feeds trim line
For model number UT26SSL3VNM
Hello Donald, thank you for asking. Based on the understanding of the issue, we would recommend checking the bump knob, part number PS16754852, to fix the issue. We hope this helps!
Lay trimmer on bench so Phillips head screw on end of shaft just above trimmer head is up. Turn trimmer head until you see a gap open just below screw. Insert Allen wrench in gap. Hold in on Allen wrench with one hand while turning trimmer head to the right. Reverse threads lefty tighty ,righty loosey.
