TW0350 Makita Impact Driver - Overview

Included in Part Number 539168-0

This is an original Makita part for use in saws, drills, nibblers, planers, polishers, sanders, and shears. The flat washer goes between the gear shaft and the needle bearing. During the installation process, an allen wrench and a set of pliers might be needed to replace this part. It will need to be replaced if it becomes broken. This is made of metal and is sold individually.

The urethane ring fits between the screw and the stopper arm. This part is sold individually and is an OEM part sourced directly from the manufacturer. It is used in Makita miter saws and impact wrenches. You may need a screwdriver when replacing this part. It will need to be replaced if it becomes broken.

Genuine Manufacturer Sourced replacement part used on a variety of Makita Power Tools. This is a Metal Pan-Head Screw and it is sold individually. This screws is commonly used to hold two pieces of Housing Set together.

This brush cap is a genuine OEM sourced replacement part. It is commonly used on a variety of Makita power tools. This brush cap helps to secure the carbon brush in the brush holder. This cap has external threads that will thread into the opening in the housing. This item is made out of durable plastic and it is sold individually. It has ...Read morea convenient slot that makes it easy to secure or remove it using only a flat-head screwdriver.

Length 8 Foot Length: 6' Gauge: 18 Wires: 2 Type: Bare Wire This power supply cord is a genuine OEM sourced replacement part. It is specially made to supply power from a standard outlet to Makita power tools. A cracked or damaged cord should be replaced before continuing to use the tool. This rubber insulated cord is sold individ...Read moreually. It comes with a rubber sleeve grommet that is not sold separately. Replacing this power supply cord you will need a screwdriver. • Remove the housing screws • Remove the the housing • Disconnect the old cord wires • Remove the old power cord • Secure the new cord in place • Connect the wires • Reassemble and test the new cord

This genuine manufacturer-sourced part is specially designed for Makita power tools. It is an important component which provides a tight seal between connected components. Unfortunately, over time it will wear out and it may begin to crack eventually requiring a replacement. To ensure the correct repair procedure, refer to the appropriate...Read more diagrams for your model. Note, this high-quality insulation washer is made of durable material and is sold as an individual item. A screwdriver will be needed to take apart and reassemble the tool when performing this repair.