TM3000CX5 Makita Multi-Tool - Overview

Included in part number 515616-3

This is a genuine Makita replacement part that has been OEM sourced to ensure quality. The self-locking clip is intended to be used with laminate trimmers, angle grinders, jig saws, wet stone polishers, routers, and multi-tools. This item is used to secure a part assembly along a shaft. The application of the self-lock can vary based on t...Read morehe model of your equipment. It is recommended to review your model's part diagram to verify this part's compatibility and usage.

The brush holder attaches to the carbon brush. This is a genuine replacement part sourced from the original manufacturer for use with grinders, multi-tools, and plate joiners made by Makita. This item is made of metal and is available individually. When replacing this part a screwdriver might be required during the installation process. It may become broken and will need to be replaced.

This is a genuine OEM replacement part used with Makita power tools. The terminal block is utilized to secure and connect the wires. It is an identical replacement for a damaged or a missing component that was installed on a new unit. Refer to the appropriate diagrams for your model to ensure the correct repair. Keep in mind this high-qua...Read morelity terminal block is made of durable materials and is sold as an individual item.

Length 8 Foot Length: 6' Gauge: 18 Wires: 2 Type: Bare Wire This power supply cord is a genuine OEM sourced replacement part. It is specially made to supply power from a standard outlet to Makita power tools. A cracked or damaged cord should be replaced before continuing to use the tool. This rubber insulated cord is sold individ...Read moreually. It comes with a rubber sleeve grommet that is not sold separately. Replacing this power supply cord you will need a screwdriver. • Remove the housing screws • Remove the the housing • Disconnect the old cord wires • Remove the old power cord • Secure the new cord in place • Connect the wires • Reassemble and test the new cord

This replacement tapping screw is sourced directly from original equipment manufacturer. It is specially designed for Makita power tools. It is a standard hardware which has multiple applications based on a tool. Please make sure to check appropriate diagrams for the location and use of this screw. This part is made out of metal and it is...Read more sold individually. Requires a screwdriver to tighten/loosen this screw. This is a self tapping screw can tap its own hole as it is driven into the material.

It is made out of metal and is sold individually. The wave washer fits between the labyrinth rubber ring and the magnet sleeve. A set of pliers and a screwdriver might be helpful during the installation of this part. It will require replacing if it breaks. This is a genuine Makita part sourced directly from the manufacturer for use in sanders, grinders, trimmers, and saws.

This Ball Bearing is sealed on both sides. This genuine Makita replacement part is sold individually. rnrn • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls reduces friction. This reduces wear on...Read more the tool, allowing it to run smoothly. rn • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.