T50S4 Bostitch Nailer - Overview

Diagrams for T50S4

See every part. Know exactly what you need.

Page A

Parts for the T50S4

$7.44

WASHER-RUBBER-7

Part #854004

This rubber replacement seal is designed for use with select pneumatic and coil-fed nailers, providing a tight and reliable seal at the nose of the tool. Its primary function is to prevent air leakage during operation, helping to maintain consistent pressure and performance. Over time, seals can wear down or become damaged, which may lead...Read more

Read less

Spring,Pusher

Part #T50036

Magazine Nut

Part #T50052

Bracket,Magazine

Part #T50103A

Kit,Trigger Valve-Speed

Part #STV2

Grip,Handle

Part #107490

Label, Trip Adj.

Part #851934

Check Seal

Part #N50034

This is a genuine manufacturer-sourced part which is made for Bostitch nailers and staplers. It helps to distribute the pressure evenly and provide a tight seal between connected components. Over time check seal may wear out, become brittle and begin to crack eventually requiring a replacement. Make sure to check the appropriate diagrams ...Read more

Read less

O-Ring Kit (T40, T50, N50FN, N60FN N59FN)

Part #ORK1

Bumper, Top

Part #T50002

This replacement bumper is a genuine OEM sourced item that is specially made for Bostitch nailers and staplers. The purpose of this part is to keep the piston from hitting the bottom of the cylinder and damaging it. Because this part get so much abuse over time it will begin to fall apart eventually requiring replacement. This item is mad...Read more

Read less

$7.44

PIN-SPIRAL M3X30

Part #100298

It is a genuine manufacturer-supplied component which is made for Bostitch nailers and staplers. This is a special spiral pin that is utilized to secure the trigger. It is an identical replacement for a faulty or a missing hardware that was installed on a new unit. To ensure the proper repair procedure, refer to the appropriate diagram fo...Read more

Read less

$7.44

SPRING-COMPRESSION

Part #100387

This compression spring is an OEM direct from Bostitch. The metal spring is compatible with many stapler and nailer tools. This item is fitted within the trigger valve kit of the device. The spring is the mechanism for the trigger to move back in place. Although this part is sold individually, it can also be found in the SEQ6 Kit. A small hammer and a hex key are helpful in the repair.

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

would not fire nails

10 of 15 people found this instruction helpful.

Richard from Bogalusa, LA
A Bit Difficult
30 - 60 mins
Pliers, Screw drivers

remove 2 Philips head screws, drive out drift pins with drill bit. Remove TVA6 replace with new TVA6 making sure TVA6 is completely seated and slots are aligned with drift pin holes! Drive in drift pins. Replace trigger and screws.
This did not solve the problem as suggested by Parts select.
Replaced Head Valve Seal...Problem re ... Read more

Read less

Was this helpful?