ST200 (Type 2) Black and Decker Trimmer - Overview

This is a Genuine Manufacturer Sourced replacement part used on a variety of Black and Decker Trimmers/Edgers. This item is Sold Individually. Switches are a commonly replaced part in power tools, handling on/off operations. Because switches use mechanical internals, they will degrade and wear out over time, eventually requiring replacement.

This genuine Black & Decker replacement spool cap is designed to hold the spool and bumper securely inside the spool housing of your trimmer. It features two snap-in tabs that make installation and removal quick and easy—just press the tabs to release it from the housing when it’s time to replace or clean. Made from durable plastic, this ...Read morepart is sold individually and measures 2-5/8 inches wide. If your current cap is cracked, missing, or no longer holding the spool properly, this is the part you need to get your trimmer back in action. Be sure to check your model’s diagram or manual to confirm the correct fit.

Keep your trimmer cutting cleanly with this genuine DeWALT replacement spool. Designed for the models listed below, this OEM part comes pre-loaded with 20 feet of .065-inch diameter cutting line, making it quick and easy to swap out when your line runs low. Built for durability and performance, this spool ensures smooth, efficient trimmin...Read moreg and is sold individually. For best results, always use .065-inch diameter line when refilling.

Genuine Black and Decker replacement part, it is sold individually. The purpose of the 682235-00 spring is to keep tension between the spool and the spool housing. Overtime the spring will lose its tension and will have to be replaced.

This is a specially designed replacement terminal made for use with a variety of power tools. The purpose of a terminal is to allow user to easily connect a wire. One end of a terminal will allow to secure the wire, while the other end has an opening allowing user to secure it with a screw. Because this terminal is made out of conductive ...Read moremetal it will transfer the electricity through itself. Please note it is sold individually.

This is an authentic replacement part sourced directly from the manufacturer. The shim washer is commonly found in Black & Decker trimmers and edgers. This part is made of metal, and is used in the clamshell housing to ensure that the motor and mount are seated securely. You will require a screwdriver when replacing this item. The shim washer is available as an individual replacement part.

This is a genuine DeWalt replacement part that has been sourced from the original manufacturer to be used with electric trimmers. The copper contact is used to link the switch assembly to the extension cord assembly. This contact is sold as a single item, please note the other contact is sold separately.

This is an authentic replacement part that is sourced from the original manufacturer for use with hedge trimmers. The special screw is commonly used to secure the front guard assembly. This screw is sold as an individual replacement part, please note four screws may be required.

This is a genuine manufacturer-sourced item that is specially designed for use with DeWALT, Porter Cable and Black and Decker equipment. It is an identical replacement for a missing or damaged screw that was installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application o...Read moref this hardware. Keep in mind this high-quality screw is made of durable metal and is sold individually.