SHS5AV55UC Bosch Dishwasher - Instructions

pushed with thumb pressure and snapped rollers into place.....EASY

There were 5 rollers still in place so I used them to show me how to snap the replacement roller in place.

Remove the dishwasher from under the counter. Remove door springs. On the inside of the lip of the door remove the 6 screws that hold the outer door panel on, and remove panel. this will expose hinge screws. Remove the two screws per side holding the inner door to the hinge assembly. Take pictures of the way the gasket's grey plastic end cap assembles between the inner door frame and the hinge, and remove the inner door. The old gasket has a channel lip that sits on the plastic edge of the washer tub, pull it off this lip and discard. Install new gasket and put it all back together! Use this opportunity to clean the gunk out of the upper door seals.

replacing the control unit was fairly simple, just pop the old one out and plug in the new one, but didn't solve the problem, it's a float sensor that doesn't show up on the tech sheet in the dishwasher or anywhere in troubleshooting on the internet I could find.

I watch utube to assess the problem then took eveything apart and saw the build up on the filter, which i had never cleaned. I tried to clean it but was unsuccessful so order the filter from partselect and it came within a couple of days, installed very easily and began to clean as it always had.

Really simple. You pull out the drain filter plate and pull the filter off the support and replace. I gave everything a good cleaning and put it back in place.

This repair was relatively easy and saved us literally hundreds of dollars as well as time...we were looking at 3+ weeks for a technician to come out. And that was just to diagnose. The hardest part was my own lack of experience and getting the dishwasher out because of a poor installation. The best part was identifying and ordering the part from PartSelect. The part came quickly...within 2 days. I had ordered a wrong part previously and they took it back no problem. Very pleased with the whole process and their help videos.

Replacement was fast and very simple. Was completed in less than 5 minutes.

replacing the sensor was simple, just unplug and turn it out, but didn't solve the problem, it's a float sensor that doesn't show up on the tech sheet in the dishwasher or anywhere in troubleshooting on the internet I could find.

We followed the video and had no problems with leaks at all afterwards. The parts fit perfectly and the machine is working great again.

Tried the door lock first. Did not fix the problem.

Replaced the drain pump and it fixed the problem.

Parts Select identified the pump as the most frequent problem.

Next time I will order both parts when one is cheap for any repair.

Find Parts Select is very helpful. They have identified a problem with a washing machine in the past.

I will use them for future problems.

Removed old discharge pump and replaced it with the new one. After four attempts the dishwasher worked once. This cycle continued for the next 3 attempts then it stoped all together. Ordered the sensor, installed it snd the dishwasher still doesn’t work! Now what do I do???

Turned power off, disconnected plug from switch, R&R switch, reconnected plug and restored power

I bought replacement wheels.
I put them on the post, and they snapped onto the vertical post very easily. Job done.

Mistakenly opened covers for the drain pump. Had to put those covers back in place.
Heater and pump installed easily with a bit of careful maneuvering the plugs and plug housing from the exterior. Pump installed in place easily. Clamp fit perfectly.