Models
>
SHE6AP06UC
SHE6AP06UC Bosch Dishwasher - Overview
Models starting with SHE6AP06UC
Click on the best match to narrow your results.
Keep searches simple, eg. "belt" or "pump".
Rack Roller Wheel
PartSelect #: PS8727423
Manufacturer #: 00611666
This kit comes with one axle and one roller.
$12.76
In Stock
Drain Pump - 55Hz
PartSelect #: PS8727352
Manufacturer #: 00611332
The pump ejects the water from the dishwasher through the drain hose.
$75.78
In Stock
Adjustable Tine Row Clip
PartSelect #: PS8727471
Manufacturer #: 00611981
This part is a replacement tine row clip for your dishwasher. The tine row clip is adjustable, and it fits onto your dishrack to holds the tines into place. If your dishrack tine rows will not stay in...
$7.47
In Stock
Water Inlet Valve
PartSelect #: PS8726680
Manufacturer #: 00607335
This is a replacement water inlet valve for your washer. The water inlet valve in your washer connects to the water source and solenoid wires, and ensures the tub has the right amount of water enterin...
$87.29
In Stock
Common Symptoms of models starting with SHE6AP06UC
[Viewing 9 of 9]Leaking
Fixed by
these parts
these parts
Show All
Not draining
Fixed by
these parts
these parts
Show All
Will not fill with water
Fixed by
these parts
these parts
Show All
Not cleaning dishes properly
Fixed by
these parts
these parts
Show All
Door latch failure
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Will not dispense detergent
Fixed by
these parts
these parts
Show All
Noisy
Fixed by
these parts
these parts
Show All
Door won’t close
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
The plastic clip on the roller broke
We let this go for a shameful amount of time before I decided I could probably fix it. The roller broke so you could only pull it out about halfway or it would come off the track. I looked up the part, and bought it. Actually bought two in case it happened again. When I arrived I looked at how it was put together on the other side and then just basically pushed it onto the rod and it was fixed. I am ashamed it took so long to do it. Never be afraid to try it yourself. It was a total of $10 shipped to fix it.
Parts Used:
-
Catherine from AMHERST, NY
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
20 of 27 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Drain Pump runs continuously - inlet valve leaking into bottom tray
disconnected inlet hose and water line from sink, removed old inlet valve and installed new valve and reconnected inlet hose and water line from sink - checked for leaks.
Parts Used:
-
Terry from BIRMINGHAM, AL
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers, Screw drivers
6 of 9 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Would not fill with water. Pump sound like it was running when starting cycle
It was necessary to pull the dish washer to access the valve located on the lower left front of machine. Some difficulty in disconnecting water inlet and outlet hoses to valve since spring clips used to secure hoses. Tight spaces to remove the old valve and install new valve. Used screw type hose clamp on reinstall in lieu of spring clips. May have been easier had I had the special pliers used to remove and install spring type clips.
Saved a minimum of $100 for service call.
Saved a minimum of $100 for service call.
Parts Used:
-
Max from JENKS, OK
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Pliers, Socket set
4 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!