RY28025 Ryobi Trimmer - Overview
Sections of the RY28025
[Viewing 3 of 3]
Keep searches simple, eg. "belt" or "pump".
Hex Nut
PartSelect #: PS12654681
Manufacturer #: 678029002
Hex nut m6.3 x 1 black oxide
$5.95
Special Order
Trimmer Screw (M6 X 20 Mm)
PartSelect #: PS9989492
Manufacturer #: 660697002
It is a genuine replacement part that is supplied directly from the original equipment manufacturer for use with Homelite and Ryobi handheld trimmers and brushcutters. This is the main screw used to s...
$5.95
Special Order
Screw (m4 X 19 Mm)
PartSelect #: PS9989642
Manufacturer #: 660968001
This is a genuine manufacturer-sourced replacement screw which is specially designed for use with Homelite and Ryobi handheld lawn and garden equipment. It is a standard hardware which has multiple ap...
$5.95
Special Order
Crankcase Cover
PartSelect #: PS9987765
Manufacturer #: 638337005
This is an authentic replacement part sourced directly from the manufacturer. The crankcase cover is commonly found in yard tools from Ryobi and Homelite, such as trimmers, blowers, pruners, and edge...
$5.95
Special Order
Heat Shield
PartSelect #: PS9987793
Manufacturer #: 638442001
It is a genuine item that is supplied directly from the original equipment manufacturer for use with Ryobi and Homelite handheld lawn and garden equipment. This is an identical replacement for a missi...
$5.95
Special Order
Heat Dam
PartSelect #: PS9964606
Manufacturer #: 518497001
It is a high-quality replacement part that is sourced directly from the original equipment manufacturer for use with Homelite and Ryobi handheld lawn and garden equipment. Heat dam acts as a spacer fo...
$5.95
Special Order
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
bearing set up in lower shaft.
-
Irvin from BURR OAK, MI
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Socket set
3 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
THE DRIVE SPLINE IN THE MIDDLE OF THE SHAFT WOULD NOT ENGAGE
-
JAE from MILL HALL, PA
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
3 of 5 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
didn't keep running
removed outer cover, remove old gas lines from carburetor and gas tank. Unscrewed (2) screws holding carburetor. Making certain not to damage gasket under carburetor then installed carburetor using same gasket and screws that held it before. Tightened to snug fit. Installed new gas lines, and cover over carburetor.
Parts Used:
-
edward from ALLEN, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers, Socket set
1 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!